0
Usually in every vehicle the brake lights come on when the brake pedal is pushed in. There is a switch connected to the pedal in some way to make the light switch on.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
What causes the Brake light on 2000 Chevy blazer to come on?
b/c light fool
What causes the brake light on a 200 Chevy blazer to come on?
If nothing is holding the pedal down then the brake light switch is at fault.
How do you know if your brake switch is bad for a 2001 blazer?
If the brake light fuse is good and the brake light bulbs are good it's probably a faulty brake light switch.
Where is the location of the brake light switchon1997 Chevy blazer?
Directly above the brake pedal.
How do you replace the brake light switch on a 99 Chevy Blazer?
you can find the switch on the back of the brake pedal.
How do you reset 95 Chevy blazer brake light?
The brake light is on because there is a problem with the brake system. Until the problem is fixed the light will remain on. Once the problem is corrected the light will reset itself.
Replace brake replace brake light 1995 blazer?
Your brake light is probably brake fluid low or emergency brake on. Rear brake lights are replaced by removing the lens and replacing the dual filament bulb.
Why is my brake light on in a 1992 Chevy Blazer?
you most likely need to change them
1991 Chevrolet s10 blazer warning brake light always on anybody knows?
If a 1991 Chevrolet S10 Blazer warning brake light always stays on, it could just be a malfunction of the light. To reset it, disconnect the battery for 10 minutes.
Why is your brake light on 1996 Chevy Blazer?
It could be low on brake fluid, a sign of trouble. Have the brakes checked SOON!
2001 chey blazer brake lights dont work third brake stays on?
The 2001 Chevy Blazer brake lights may not work and the third bake stays on because the current light needs to be replaced. A replacement brake light can be purchased at an Auto Parts store like Pep Boys.
How do you replace a high mount brake light on a 2002 Chevy blazer?
Remove the wiring harness from the high mount brake light. Remove the retaining screws. Reverse the process to install the new high mount brake light.
