Headlights Tail and Brake Lights
Chevy Blazer

Why is my brake light on in a 1992 Chevy Blazer?


Top Answer
User Avatar
Wiki User
2011-09-13 15:14:53
2011-09-13 15:14:53

you most likely need to change them

User Avatar

Related Questions

It is quite easy to install the 1992 Chevy Lumina brake light switch. The brake light switch simply plugs in and out.

No. A Chevy Blazer does not have a reset switch.

The relay is on the left side of the power brake booster/.

Check the bulbs, Check the fuse, Check the brake light switch, in that order.

The ECM on a 1992 S10 Blazer is located below the glove box.

Pull the release handle for the e brake and then while its pulled out pull up on the pedal

Put your new fan belt around the pulleys of your 1992 Chevy Blazer. Tighten the fan belt with the tensioner pulley.

By repairing the problem. Low brake fluid, defective master cylinder, etc.

if its burnt out, replace it, if not, check the wireing

The starter solenoid is attached to the starter.

brake light plunger switch on the brake pedal maybe faulty, remove it and connect the two wires together and pull apart and see if lights go on and off

Bad stop light switch? Located at the upper end of the brake pedal under dash area

Under the Dashboard on the Drivers side, has a Plastic Cover.

I live in DE and they wanted 12 to 15 hundred to do my 1992 blazer.

The signal light flasher on a 1992 Chevy Silverado is under the dash. It is on the driver's side just above the brake pedal.

the brake light switch is on a bracket just above the brake pedal.

Normally this is an indication of a defective brake light switch.

There should not be one for the interior light.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.