Want this question answered?
Pneumatic schematic in the air brakes in any type or build of truck all work in coordination with each other for smooth driving. The brakes would not be able to smoothly stop without them.
remain calm and continue driving in the same lane. Begin to apply the manual emergency brake with your hand, lightly at first to determine the strength. You dont want to lock up the brakes, so apply the emergency brakes in spurts and make your way to the side of the road.
A common reason is that the front rotors have warped. Go check out WikiAnswers on the topic of "warped brake rotors". Rotors should wear out smoothly in normal driving. Use of the brakes that generate lots of heat (hard braking, riding the brakes) will result in warped rotors.
Your brake might grab when going downhill because the pads are wearing out. The lines may also need bled properly.
i have a 93 nissan and the front brakes are getting hot when driving
Apply the brakes. Do not 'pump' the brakes ... that's what your dad learned, in the 70's. ABS means that the brakes will automatically apply and release in micro-second bursts (faster than you could ever do it) to prevent the brakes from locking up and to prevent the tires from skidding. All you do is hold the brake pedal down, steer in the direction you are heading in case you start to skid, and then smoothly accelerate.
Apply the brakes. Do not 'pump' the brakes ... that's what your dad learned, in the 70's. ABS means that the brakes will automatically apply and release in micro-second bursts (faster than you could ever do it) to prevent the brakes from locking up and to prevent the tires from skidding. All you do is hold the brake pedal down, steer in the direction you are heading in case you start to skid, and then smoothly accelerate.
Test brakes lightly after driving through deep water.Brakes may pull to one side or may not hold at all.Dry brakes by driving slowly in low gear and applying brakes.
Yes, that will work.
No
Yes, it is already in the control system. It has to.
Smoking brakes usually indicate a stuck caliper or improper install on pads/shoes. Have you calipers checked and make use they move smoothly.