answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: When emitter resistors is bypassed with a capacitor how is the gain of the amplifier affected?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Engineering

Why is gain affected when the bypass capacitor is open?

Applied input signal at the base of the amplifier appears across the emitter resistor (RE) due to inter electrode capacitance so it should be bypassed the emitter resistor (RE) through the bypass capacitor (CB). unbypassed signal will be amplified (common emitter amplifier) and reverse back from the emitter to the collector through the base, amplified signal from the emitter to the collector (common emitter amplifier) is 1800 out of phase to the amplified signal from the base to the collector (common base amplifier), so reduced the gain.


How does coupling capacitor couples two stages in a multi stage amplifier?

A: it could be both coupling meaning eliminate DC from the source or decoupling whereby unwanted signal is bypassed to ground


How much signal voltage should be measured at the bypassed source of a common source amplifier?

the same amount as the drain


Cold air from a heating unit?

I'm guessing this is in a car, truck, or van since it is in that category.Diverter door malfunction: Most if not all cars use a diverter door to push air past either the Heater Core, or Evap (air conditioning); these doors are controlled by a vacuum pot (hose and line) in most cars, and by electric means (In rare instances). You will need to find specifics about 'your car' to tell what type, as well as its location to see if 'that' is the problem.Some cars use a valve on the heater line (the line that allows hot water to enter the heater core) if this valve is damaged, or stops working, then hot water will not reach the core to provide heat.There is always the case that someone has bypassed the heater core (disconnected it) as well.That should give you enough information to start at least.


How does bypass produce thrust in turbofan engine?

There are two types of turbofan engines- high bypass and low bypass engines. About 80 percent of the total engine thrust from a high bypass turbofan engine is produced by the bypass of air around the core. These types of engines generally have a large fan in the front to pull in large volumes of air to produce such a powerful jet stream out the back. The front fan is driven by the compression, combustion, and expulsion of the hot gases out the back of the core. About 20 percent of the air pulled in from the front fan is used to drive the core. High bypass turbofan engines are used on almost all commercial jet aircraft because they burn less fuel. A low bypass engine is exactly the opposite. The core is used to drive a smaller fan in the front which only about 20 percent of the total volume of air pulled in is bypassed. The remaining 80 percent of the air being drawn into the engines core is compressed, combusted, and the hot gasses expelled out the back to produce the necessary thrust to propel a jet forward. Low bypass turbofan engines are found on jets that require supersonic speeds. These engines are incredibly powerful but at the cost of a high fuel burn rate.

Related questions

Why is gain affected when the bypass capacitor is open?

Applied input signal at the base of the amplifier appears across the emitter resistor (RE) due to inter electrode capacitance so it should be bypassed the emitter resistor (RE) through the bypass capacitor (CB). unbypassed signal will be amplified (common emitter amplifier) and reverse back from the emitter to the collector through the base, amplified signal from the emitter to the collector (common emitter amplifier) is 1800 out of phase to the amplified signal from the base to the collector (common base amplifier), so reduced the gain.


How does coupling capacitor couples two stages in a multi stage amplifier?

A: it could be both coupling meaning eliminate DC from the source or decoupling whereby unwanted signal is bypassed to ground


How much signal voltage should be measured at the bypassed source of a common source amplifier?

the same amount as the drain


Why would the gain go up in a circuit board when you put an emitter capacitor in the circuit?

The emitter resistor is there to provide DC bias to the base. If it is not bypassed, then the AC output signal is also dropped across this resistor, effectively lowering the output swing. When a bypass capacitor is added, the DC bias still flows through the resistor, but the capacitor acts as a short circuit for the AC signal, so that the AC signal is not reduced. The capacitor selected must be large enough so it appears as a very low resistance at the lowest frequency the amplifier will pass.


How capacitor works practically?

infact what happens in practical capacitor action that air in between parallel plates of that capacitor it acts as a dielectric medium and leakage current starts flowing, that leakage curent is then being bypassed through a conductance in parallel with the capacitor.But in the ideal case that leakage current can't flow due to infinite resistance which can not be provided practically.


Which organ is bypassed in the special circulation pathways of a fetus?

The liver is partialy bypassed


Can the heater core be bypassed until a replacement can be made?

yes the heater core can be bypassed by connecting the heater hoses together


Why is pulmonary circuit bypassed in the fetal circulation?

The pulmonary circuit is commonly bypassed in fetal circulation. This is because fresh blood is provided by the mother to the fetus.


How do you replace the audio amplifier in a television?

In some older rear projection televisions, the audio power amp is separate from the video chassis. It can be bypassed or replaced. But in most (if not all) flat screen televisions, the audio power amp is integrated into the set, and cannot be readily replaced. It can be repaired, but I don't think that is what you were asking.


Can steering column be bypassed to rewire turn signals in 89 Chevy Corsica?

The steering wheel cannot be bypassed to rewire turn signals in a 1989 Chevy Corsica. The switch for the wires is in the steering column. If the steering wheel were bypassed, the wires would not be connected to the switch.


What was the line in France bypassed by the Germans?

Maginot Line


How can the hepatic first-pass effect be bypassed?

sublingual