answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: When installing a tabletop equipment on legs the space between the base of the equipment and the tabletop must bhe at least what inches?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What are the boards called that run along the edge of a table and hangs down four or so inches from underneath the tabletop?

This board is typically called the "apron". It runs between the table legs and attaches to the underside of the tabletop. Hope that helps.


How big is a table that is 130 inches long and 88 inches wide?

Assuming these measurements refer to the top of a rectangular table, the surface area of the tabletop is equal to 130 x 88 = 11440 square inches.


Can a 320GB hard drive will shrink to what size after installing Vista home premium 64bit?

2.5 inches :l


How many inches are in 23.1 Cu ft?

You can convert between feet and inches, or between cubic feet and cubic inches. You can not convert between cubic feet and inches.


Where is 5.5 inches on a ruler?

It is in between 5 inches and 6 inches


How close can a gas dryer be to an electrical panel?

A space of 30 inches or the width of the electrical equipment is needed, whichever is greater, for electrical equipment.


What is the difference between 59 inches and 61 inches?

2 inches


What is the dimension of a bowling ball?

A bowling ball has an initial circumference between 26.704 inches and 27.002 inches with a diameter between 8.500 inches and 8.595 inches.


How many inches above the floor should stationary equipment be installed at a minimum?

8


What is the difference of 1.58inches and 2 inches and?

The difference between 1.58 inches and 2 inches is: 0.42 inches.


How many yards of fabric are needed to make a tablecloth for a 30 inch round table?

You would need enough fabric to make a circular cloth ten feet in diameter (assuming you mean the tabletop is a circle eight feet in diameter - you aren't exactly clear on that - whether the tabletop is 8 feet in diameter or 8 feet in circumference).


When installing waste-linewhats the angle ordegree of angle inches per foot?

x2 8 sjyybvcxsd ewwss S,,;F,LDAc