i believe fuiel filter and fuiel pump is one unit inside the gastan for 2003 Toyota 4 runner V8.
You acces the oil filter on the 4cylinder engine through the passenger side front wheel well. There should be an acess area for you to go through.
Your 2004 Toyota 4Runner has a timing belt if it is a V8. This belt must be replaced every 90,000 miles. Warning: This is an interference engine. Severe engine damage will be done if the belt breaks. If you have a V6 then it has a chain which should last the life of the engine.
It should last the life of the engine and is normally replaced during an engine overhaul.
Yes, it should fit perfectly.
if you have the correct tools and professional help it should work.
The Toyota 4Runner light truck has been in continuous production for multiple years as of September 2014. For these reasons the exact intake and air filter plenum design varies by model year. For the 2014 4Runner with the 3.4L V6 removal and installation new panel filter requires two steps. The first is opening the hood and locating the air filter box, This is located on the air hose following the engine's intake manifold. The air filter can be accessed, inspected and then replaced by opening the retaining clips of the box itself. These may be very tight. Before replacing with the new filter element the surfaces and box should be clean of any debris and other dirt. The OE replacement air filter for this application is Denso #1432077.
Follow the transmission dipstick which is located just below your right windshield wipers in the engine bay. You should see a pan with a 10mm bolt ref. to auto trans 1999 toyota 4runner
WHEN SHOULD TIMING BELT BE CHANGED ON A 2000 TOYOTA 4RUNNER SR5? talktoenock@comcast.net
I have a 1985 celica GT and the fuel filter is located above the oil filter on the engine block. If the ST model has a 22re engine it should be the same.
If the brakes on a 2003 Toyota 4Runner are locking up there is a problem with the calipers. The units should be inspected for wear, to avoid any serious injury.
5 quarts
17 in wheel, should be 21mm socket