answersLogoWhite

0


Best Answer

Get number 1 cylinder up to top dead center on the compression stroke and rotate the dist, rotor to the number 1 plug wire when re installed in the motor the dist make take several attempts cause as it is installed it turns as it messes the cam gear.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: When the distributor has been removed and the engine turned over what is the procedure for getting timing set right when reinstalling the distributor?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What gland is removed in a prostectomy procedure?

The gland this is removed in a protectorate procedure is the prostate gland, which is removed from the surrounding tissue. They might even check for cancer at the same time.


Can you die from getting your womb taken out?

This is a surgical procedure called hysterectomy. During a general hysterectomy, the uterus (womb) is removed. An Oophorectomy is sometimes also performed where one or both ovaries are also removed.


What is an procedure in which the gallbladder is excised or removed?

cholecystectomy


In order to remove the intake manifold on a 1999 Chevrolet Suburban 5.7 do you have to loosen or remove the distributor?

Yes you do. The distributor must be removed.


What procedure removes a blood clot?

The procedure were a blood clot is removed from a vein is called an embolectomy.


How can you get supernumerary nipples removed?

Yes, it is a common procedure


How do you install a distributor in a 1996 Yukon?

I removed the distributor in my 96 gmc yukon but I forgot to mark it before removing it.What do I need to do to get it back in.


Do you have to removed the distributor off engine to change pick up coil?

Usually, NO.


How do you set distributor timing on a 2001 mercury villager?

Timing is set by the PCM and is not adjustable. The distributor should always be reinstalled in the same position it was removed from.


Does the magnet on the distributor shaft slide off?

The distributor will need to be removed. The magnet is permanently attached to the distributor shaft and the shaft is held in place by a roll-pin thatpasses through the distributor drive gear on the bottom side of the distributor. Magnet on top, gear down in the engine, distributor shaft and housing in the middle.


What is the procedure in which fluid surrounding a developing baby is removed?

Amniocentesis


Where is the ignition condenser located on a 2003 Toyota Highlander?

The ignition condenser is located inside the distributor. In order to repair the issue, the distributor will need removed and replaced.