0
When the ignition is in the on position the abs pump motor assembly keeps the accumulator charged to a pressure up to?
Wiki User
∙ 12y ago
100 psi
Wiki User
∙ 12y ago
Anonymous
Amir Abdallah
1200
Add your answer:
Earn +20 pts
Do you have to turn on the switch to reset the tire pressure light?
Yes, the ignition switch must be in the ignition position -not- the accessory position.
Jaguar XJ6 '89 getting abs brake failure low brake pressure -is it abs accumulator round black ball Please help?
Low brake bressure can be caused by a worn accumulator, poor pump performance, a bypassing brake booster or an inaccurate pressure sensor. To test your brake accumulator, turn the key to the on position and pump the brake pedal. A properly functioning accumulator will give you 25-30 brake applications before the low brake pressure light illuminates
How do you reset the Low Tire Pressure display on a 2003 impala?
While the ignition is in the ON position, follow this sequence:Turn your headlights to the parking position and then OFF 3x's.
After 1983 Volkswagen Rabbit gti sets for about 20min it is hard to start?
Check the check valve located at the inlet of the fuel pump for leaks. It sounds like the fuel accumulator has failed. get under car , remove fuel pukp and accumulator assembly. Remove fuel accumulator, drain unit. Shake unit, if it has fuel inside it has an internal leak and must be replaced. The engine heatsoak causes fuel to boil, the accumulator maintains pressure to prevent this issue.
What does an accumulator in a brake system do?
The accumulator stores brake fluid under very high pressure. An electric pump keeps the accumulator pressurized with brake fluid. When you press the brake pedal, pressurized fluid from the accumulator operates the brakes.
What is a brake accumulator?
A brake accumulator is a device that holds brake fluid at a very high pressure. It is an important part of a proper brake system.
Where is the low pressure ac valve on a 95 Pontiac sunfire?
at the accumulator
What causes ac compressor to not disengage?
pressure switch located on the accumulator
What does a hydraulic accumulator do with energy?
A hydraulic accumulator contains a bladder filled with a compressible gas, usually nitrogen. The pressure of the gas in the bladder is known as the pre-charge, and will vary based on the ambient temperature. Hydraulic oil is pumped into the accumulator but outside of the bladder. As the oil is pumped in, the bladder compresses, which exerts a force on the oil. There is usually an pressure transducer in the system which will signal the hydraulic pump to turn off when a certain oil pressure is reached in the accumulator. A hydraulic accumulator can have several uses. It can be used to store hydraulic pressure for later use. It can be also used as a type of "shock absorber" for hydraulic systems.
What is the minimum allowable brake accumulator pressure required for tow?
3000 PSI
Where is the low pressure recharge valve on the 1993 gmc surburan?
Its on the a/c accumulator..............
Who sells high pressure brake accumulator for Mercedes?
the mercedes dealer ship:P
