There may be a hole in the heat exchanger allowing the combustion gases to mix with the air that circulates into your home. another possibility is an oil leak that allows fumes to mix with the circulating air. Call a certified oil furnace service technician to review your furnace right away. Sometimes a furnace with a hole in the heat exchanger allows deadly Carbon Monoxide to circulate in your home. You can't smell the carbon monoxide but it is deadly. Don't use the furnace until you have it serviced.You should also make sure that you have a working Carbon Monoxide detector at least in your sleeping area. Don't wait, call a heating contractor. Your life may depend on it.
Check the error code on the control board at the furnace. It could be a number of things. If the furnace is not lighting, it could be the ignitor If the furnace lights then goes out right away, it could be the flame sensor If the furnace lights then goes out after several minutes, it is a limit switch. Turn the tstat fan switch to on and see if the fan comes on, if it does not you have no power to the furnace, check the breakers or cutoff switch.
Your MOM IS A FURNACE
It could be the snot that comes out of the nose. But then again, it could be anything else.
Could be a drain for the inducer motor if it has one and it depends do you have a a/c coil on your furnace if so it could be a drain for it.
One could find information on gas furnace troubleshooting online at Ask. Hvac for beginners is also a great place to look. One could also contact their local gas furnace dealer and/or repairer for gas furnace troubleshooting.
Water leaking from a furnace most likely occurs from the heat of the furnace which transforms into a liquid. The best way to avoid the leak is to put your furnace at a lower temperature.
You could use a thermocouple.
When the furnace in your home goes out, there are a few things that you need to look at before you get a new furnace. Get the furnace serviced by a professional electrician who will check the heating coils as well as the filter in the furnace. Check the circuit breakers in the furnace to ensure that they are working properly. If the breaker is not making contact, this could be all that you need to replace.
You need a new battery.
There could be many reasons why a Kawasaki 650 jet ski won't start, but still clicks. The fuse could be blown, the wiring could be off, there may not be a lot of gas, or a solenoid could be out.
If you are looking for an American Standard furnace, and are not a fan of online shopping, you could visit a local retailer of home heating or industrial heating.
Well it could be the hot and neutral wire needs to be swapped at the furnace. And if its an older unit that this has just occur on the control board could be faulty.