answersLogoWhite

0


Best Answer

1 the water level pressure switch broken or clogged.Or the clear hose from the water level switcn is clogged.

To check, remove clear hose from water level switch and blow on switch nipple. If hear a click switch is good, check for clogg on the clear hose to the tank.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: When the washer fills with water it will not stop?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is a inlet hose on a washer?

It fills the washer with water from the source, Theres usually a cut-of valve or faucet on the wall near the washer for it.


Should you put clothes in washer before the water fills machine up or after?

before.


When Washer is draining Toilet and Tub fills up with drain water?

You have to use toilet more


Why does your Kenmore 70 Series washer not stop filling with water?

There is a clear hose attached to the water level control of the washer. The other end of the hose is attached underneath the washer. The hose isn't attached with any hose clamps so if the washer rocks from a uneven load it could come disconnected and on the next load the water fills up and never stops. Just disconnect the water and electric and the drain and turn the washer on its side look for the hose and reattach it to the hookup underneath-- I just fixed mine, I thought I was going to be buying a new washer but this one still works great now! Hope this helps- Jesse


How does toilet cistern work?

When you pull the handle a washer is lifted and the water goes down into the toilet and at the same time the cistern fills up once the washer is back in place from the flushing mechanism


Where is the toilet washer?

seal to stop water from runing into tank located between tank and bowk


How do you stop dripping water from taps?

You take the faucet apart and replace the washer and stem seal .


Kenmore washing machine will fill with water and drain off but will not spin water out or wash?

If a Maytag washer fills with water but does not agitate it could a problem with the switch in the lid. There is a switch that locks the lid down during agitation and spinning. The magnet could be defective.


How does the washing machine work?

The washing machine works by filling with water and rotating. The operator has to put in soap, bleach and softener. The washer agitates, then spins, then fills with water, then rinses by agitating, then drains again by spinning.


How do you stop a toilet tank condensation?

Install a tempering valve in water line feeding toilet. Tempering valve will mix hot and cold water together so warm water fills toilet tank which will stop condensation.


How can you stop eating lots of food in one day?

Lay down and listen to music Drink lots of water, it fills you up.


How do you get rid of extra water in washer?

You can't get rid of extra water in the washer.