0
When wire conductors are coated with solder the process is called?
Wiki User
∙ 6y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Unwanted formation of a conductive path of solder between conductors?
solder bridge, or bridging
Can you connect copper wires to tin coated copper wires?
Yes. You can twist them together and wire nut them, or solder them together.
Is lead and tin good conductor?
True
What is the process of joining two metallic surfaces to make an electrical contact by melting solder across them?
soldering
What is the cost of copper roofing?
Last "lead coated copper" roof I installed was $1,250.00 per Sq foot using 14 Oz copper with 40 -60 solder non acid flux
Unwanted formation of a conductive path of solder between conductors?
solder bridge, or bridging
Properly made and cooled solder joint will have the solder?
well wetted round both conductors, and will appear shiny and smooth.
What is iron tin?
Tinning the Soldering iron is when the hot iron is coated with solder to aid in soldering and heat transfer
What is the purpose of core in hollow solder wire?
To facilitate the soldering process, a chemical material called flux can be used to remove oxidation from the surface, keep the air from oxidizing the surfaces during soldering, and to aid in the flow of solder through the joint. Fluxes can be found within the solder (cored solder) or separately in paste form.
Can you connect copper wires to tin coated copper wires?
Yes. You can twist them together and wire nut them, or solder them together.
What should be done if during rework of an electrical component one soldering pad is torn off?
You need to create a pseudo pad with a short piece of wire connected to the same place the original pad was connected. Keep in mind that the metal conductors on printed circuit board may be coated and hard to solder to.
Is solder conductive?
A Conductor, SOLDER IS NOT AN INSULATOR. The most common types of solder are made of tin and lead. Another type is silver solder. All of the materials used are metals and are good conductors of both heat and electricity. If you solder something you would notice if you ever held a wire (without protection) while applying solder to it your finger would probably receive a burn (speaking from experience).
What has the author P A Ainsworth written?
P. A. Ainsworth has written: 'Soft soldering gold coated surfaces' -- subject(s): Gold, Solder and soldering
What is a desoldering pump used for?
A desoldering pump is a device that removes molten solder during the process of soldering. The molten solder cools in the pump and can then be removed.
Why are ciruit boads green?
Circuit boards are usually coated with a "solder mask", which prevents the solder from adhering to places where it is not desired. It also prevents corrosion of the traces on the board. The solder mask is typically made of epoxy, and is tinted green so that it can be seen easily in a visual inspection against the copper traces. Occasionally, other colors can be found.
Is lead and tin good conductor?
True
Preparing the wire by coating it with solder is called?
Tinning
