A desoldering pump is a device that removes molten solder during the process of soldering. The molten solder cools in the pump and can then be removed.
The main tools for soldering include a soldering iron, a stand for the soldering iron, and solder. You'd likely use other tools such as brushes, picks, heat sinks, solder wick, desoldering irons, etc.
A sump pump is submerged in a pit. It keeps house from flooding. A utiliity pump is used to pump water out of already flooded house, boat, pool, tank, etc....
Solder remover is an object or device for removing solder, usually from printed circuit boards. It can be in the form of a copper mesh called solder wick, a separate vacuum device you use alongside a soldering iron, or a desoldering iron. A desoldering iron gets hot like a soldering iron, but the tip is hollow and there is a squeeze bulb mounted on top. So you heat up the solder on the board and then use the bulb to vacuum up the solder and then deposit in a safe place such as a can or ash tray.
it uses centrifugal pump type to maintain pressure of 120 kg/cm2
Required slump for pump concrete is 100 -200 mm is suitable with used of admixture
A desoldering pump belongs to the category of hand tools used for removing soldered components from a circuit board or electrical connections.
There are many places where a desoldering pump can be bought. "Amazon" is a very good place. The website "parts-express" is offering desoldering pumps.
Not usually, a desoldering tool is an article that has to be bought separately. A very handy tool if you are doing a lot of circuit board work.
Removing solder so that a component can be removed for testing or replacement.
Anthony Zammit one of the directors of Phillips in Malta. He noticed that workers were taking too long an too many resources to remove solder from components using copper film and that the desoldering pump was too large and cumbersome. So he came up with the design of a small pump attached to a soldering iron which had a tiny hole drilled at the tip and turned the whole thing into a gun and called it the desoldering iron. Phillips never recognized him as the inventor and was compensated with a golden pen for his effort.
nvm got both
classification pump used in oil industries
The main tools for soldering include a soldering iron, a stand for the soldering iron, and solder. You'd likely use other tools such as brushes, picks, heat sinks, solder wick, desoldering irons, etc.
Holding pump is a pump which can hold the other pump's working. e.g for a diffusion pump another pump is used as holding pump to maintain its efficiency.
A Petrol Pump is used to put fuel into a fuel tank.
Na pump is used for signal transmission in nerve fibre.
Yes, protein pump inhibitors can be used on dogs.