There are many places where a desoldering pump can be bought. "Amazon" is a very good place. The website "parts-express" is offering desoldering pumps.
Not usually, a desoldering tool is an article that has to be bought separately. A very handy tool if you are doing a lot of circuit board work.
A desoldering pump belongs to the category of hand tools used for removing soldered components from a circuit board or electrical connections.
A desoldering pump is a device that removes molten solder during the process of soldering. The molten solder cools in the pump and can then be removed.
Removing solder so that a component can be removed for testing or replacement.
Anthony Zammit one of the directors of Phillips in Malta. He noticed that workers were taking too long an too many resources to remove solder from components using copper film and that the desoldering pump was too large and cumbersome. So he came up with the design of a small pump attached to a soldering iron which had a tiny hole drilled at the tip and turned the whole thing into a gun and called it the desoldering iron. Phillips never recognized him as the inventor and was compensated with a golden pen for his effort.
nvm got both
Yes it does. But you can not run a mechanical pump on a fuel injected engine. It will not pump enough fuel to run the engine.
The fuel pump is located in the fuel tank. Last pump I bought from Toyota was $183.00, aftermarket pumps are less expensive though.
Just did this on 1995 Grand caravan. I bought a new pump for about 190.00 at autozone. Pump is inside the tank. My mechanic installed it for 200.00.
I would start by checking the ground on the fuel pump. If it is grounded then check to see if there is power getting to the pump wit ha test light, if theres power then the pump is probally bad. If you bought it at a western auto, parts of America or a advanced auto then most likely its a bad pump, I bought one from advaned auto and there wasn't even a ground wire attached to the pump.. brought it back and the secound one didn't work at all. hope this helped..
They can be bought new for $259.00.
You should be able to obtain the oil pump installation instructions from the auto-parts store in which you bought the oil pump. The installation instructions can be found at most Harley-Davidson motorcycle dealerships.