yes it will attract in the same place
Cut one in half, and see if the two bits attract or repel one another. If they do, you have cut the magnet. Otherwise the rod. If you are allowed other equipment, you don't need to cut anything. Make a coil, connect to a meter, and see which rod, when pushed in and out of the coil, induces a current.
Yes. In some cases, a magnet is a very useful tool to use with a can opener, because Without the magnet, the cut open can lid can fall into the can and it's difficult to get it out. With the magnet, once the can lid is cut open, it sticks to the magnet and does not fall into the can. Without the magnet, it's probably better to only cut open the can lid about 90% percent and pull the remaining part back, so it does not fall into the open can.
A magnet possess the four properties:-attractive property-directive property-like poles repel and unlike poles attract-poles always exists in pairsattractive property: if you bring a magnet near iron filings, the iron filing will get attracted to the magnet. this is the attractive property.directive property:if a magnet is freely suspended by a thread, it will align itself in the north-south direction. this is called the directive property.like poles repel and unlike poles attract: a bar magnet's north pole is brought near the north pole of another magnet, it is observed that the the two magnets get repelled. if the same north pole is brought near the south pole of another magnet, the two magnets get attracted.poles always exists in pairs: when a magnet is cut into pieces, it will always have two poles, that is , north and south. even the smallest magnets will have this property. it is called the dipole property.
Remains the Same
yes.when you slice a rod magnet it will still be considered as a magnet
No. You'll end up with two smaller magnets, and each will have less than half the magnetic field strength of the original magnet.
yes if you get cut many times in the same place
No, being a magnet, it has a north pole and a south pole. The two can't be separated in a magnet. If you cut the magnet in half, each half will still have a north pole and a half pole.No, being a magnet, it has a north pole and a south pole. The two can't be separated in a magnet. If you cut the magnet in half, each half will still have a north pole and a half pole.No, being a magnet, it has a north pole and a south pole. The two can't be separated in a magnet. If you cut the magnet in half, each half will still have a north pole and a half pole.No, being a magnet, it has a north pole and a south pole. The two can't be separated in a magnet. If you cut the magnet in half, each half will still have a north pole and a half pole.
The polarity of a magnet does not change if the magnet is cut into pieces. Each piece has the same polarity that it had before. In particular, if you break a bar magnet in half at the midline between the two poles, you will end up with two magnets N-S and N-S. No reversal of polarity occurs.
Yes, the North and South poles of a magnet attract each other. Furthermore, two North or two South poles will repel each other and no matter how many times you cut a magnet in half, it will always have a North and South pole.
A magnet cannot use words to create an electric current. A moving magnet will induce electric current in adjacent conductors. This is usually described in terms of the rate that magnetic flux lines connecting the opposite poles of the magnet "cut" the conductors. The more flux lines cutting the conductors per second, the more current induced.
The bar magnet becomes two smaller barn magnets.