0
What else can I help you with?
Is it possible to jump start a car with the positive cable connected first and the negative cable connected second"?
No, it is not possible to jump start a car with the positive cable connected first and the negative cable connected second. The correct order is to connect the positive cable first and then the negative cable.
Is it necessary to use a red jumper cable to jump a car with a red battery terminal?
No, it is not necessary to use a red jumper cable to jump a car with a red battery terminal. The color of the jumper cable does not affect the functionality of the jump-start process.
Can you jump start a motor bike from a car?
Yes, just be careful what the cable ends touch.
What to do when Camry 2006 wont rev and no cruise control after jump starting battery?
This car has an electronic throttle control cable] that controls the flow of air through the throttle body. You might want to look for a blown fuse since you said you had to jump start the car.
How do you jump start a car, and should the red or black cable be connected first?
To jump start a car, first connect the red positive cable to the positive terminal of the dead battery, then connect the other end of the red cable to the positive terminal of the working battery. Next, connect the black negative cable to the negative terminal of the working battery, and finally connect the other end of the black cable to a metal surface on the car with the dead battery, away from the battery. Start the working car and let it run for a few minutes before attempting to start the dead car. The red cable should be connected first.
Intrepid will not start clicking noise?
With this symptom, if you tried to jump start the car it would start. The answer was a corroded Black/Cable going to the Negative terminal of the Battery.
What would cause your 2004 jetta not to start without a jump then when you stop the car it wont start again?
bad battery or loose battery cable
How do you jump start a 2007 Chevy impala?
Just like you jump start any other car. Connect positive cable to positive post of battery and connect negative to any metal part of the engine or frame.
How do you demonstrate the correct procedure for jumping to start battery?
Connect positive cable of donor battery to battery of car being jumped. Then connect negative cable to negative battery post on the donor car and lastly to a ground point on the car needing the jump start, normally the engine. Do not connect to negative post of battery needing a jump start. Let donor car run for about 5 minutes and then attempt to start. The instant the engine starts reverse the procedure to disconnect the jumper cables.
How do jump start from a dodge charger?
there is a positive battery post under the hood of the car that you use for your positive cable hook-up and then connect your negative cable to any metal portion on the engine.
How do you get in trunk of Chrysler 300 2006 if battery is completely dead?
You jump start the car from the jump start posts under the hood. You can then open the trunk with the button on the dash.You jump start the car from the jump start posts under the hood. You can then open the trunk with the button on the dash.
How do you jump start a Vauxhall sintra?
connect positive lead to cable nut at front of fuse box, and earth at bolt securing the bar to the car
