answersLogoWhite

0


Best Answer

I had the same problem after I replaced my outside motor. Water was literally spurting from inside the outgoing drain. I disconnected the inside drain line going out and a big wad of dirt, dust and whatever came out like a big snake. I then cleaned the rest of it with bleach and it drains like it is supposed to now.

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: When you run the air conditioning on the furnace central air water is flowing onto the floor what could be the problem?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Engineering

When phase and neutral are glowing what is the problem in circuit?

There is more current flowing and the wire can not flow that much current.


How often should you repressureise your central hearing boiler?

You should not have to. If you do it means you have a problem.


How do solve problem of furnace condensation line from freezing up outside our building andthis causes our furnace to stop?

It is generally (pretty much always) a no no to run a furnace condensate line to the outdoors, there is no avoiding this freezing up and stopping your furnace short of wrapping it with electric heat tape, which would be a bandaid at best and no more cheaper than correcting it. If the furnace is running condensate outside, I have to assume there is no drain near by. The best solution is to install a condensate pump, which the furnace and AC can drain into, and it then pumps to a different location indoors, like a laundry stack, or if you must, tap into a drain pipe with the proper fittings. If this is above your skill level, it would not be a bank buster to call a good contractor and have done. The pumps are about $60 in my area, and you can figure 1/2 hr to 3/4 hour to install by a contractor.


When should you use em heat on the thermostat?

EM (or emergency heat) can be used if you have a problem with your other heat source such as a heat pump. In most cases, you will not need this but what it does is bi-passes the primary heat source and allows your secondary heat source (normally your furnace) to become the primary.


If a central heating system cannot be installed as per the client's original specification what should a domestic gas engineer do?

If a central heating system cannot be installed as per the client's original specification what should a domestic gas engineer do?

Related questions

What is the problem of operating a on-load furnace transformer with center tap?

What is the problem of operating a on-load furnace transformer with center tap


Should I replace a central air conditioning system vs repair it?

Average life expectancy on most central AC units is about 15 years. If it keeps leaking freon, replace it and the lines going to the heat exchanger. Also, be sure the heat exchanger is not the problem (the part inside the house with the furnace that feed air into the ducts). You may be able to get a few more years out of it by repairing it now, depending on what's wrong.


Where can my company find air conditioning services to fix this problem?

you can go to a hvac company near you. you can call central air conditioning and installing company. you can call lennox air conditioning.you can call austin air condtioning and repair.


How to Fix oil furnace?

Can you be a little more specific about the problem?


Is it a problem to connect a furnace humidifier to the hot water tank?

no


Furnace Repair ?

form_title= Furnace Repair form_header= Keep the temperature comfortable when you repair your furnace. How old is your furnace?*= _ [50] Has the furnace ever been repaired?*= () Yes () No Please describe the problem in detail.*= _ [50]


What is the problem with the iron produced in a blast furnace?

It is because it is not eco friendly


If you disconnect the tankless water heater on your furnace and have an electric hot water heater installed will there be a problem when the furnace runs to heat the house?

Not if it was disconnected properly


What is a problem with using iron straight from a blast furnace?

That iron is too brittle.


Would a bad millivolt thermopile keep the pilot light in a floor furnace from staying lit?

No, it will just keep your furnace from turning on. At least that's the problem I'm having right now with the bad thermopile in my floor furnace.


What is the central economic problem?

The central problem of any economic organization is how to provide a high SOL (standard of living) for all of its members.the central problem of modern economics is scarcity.


What is furnace ignition fault?

some problem with your furnace that caused a safety switch to trip on the inside of your machine. Usually on units it will have leds indicating what safety the machine tripped on.