0
What else can I help you with?
Why won't my dodge caravan start in park but will start in neutral?
Start by checking the neutral safety switch. This is a switch that won't let the vehicle start if you have it in gear. If the switch goes bad it gives the symptom of not starting in park.
Will the neutral safety switch not let your car start?
If it is faulty or not adjusted correctly, yes.
Is there a switch on the clutch that could prevent a car from starting?
yes, it is a neutral safety switch. When this switch has an open circut, it will not let the car start. The switch should be located under the dash on the top to the cluch pedal.
How do you get cuts between shoulder biceps and triceps?
First let me have sex with you and then your son will have the cuts in age 5 or 7
On a 1981 Corvette why would you have to hold the ignition switch in a partial start potion to keep the engine running If you let the switch go back to the on potion the electoral will stop?
check the fuse for ingnition
If you turn switch to start and let go of switch truck dies?
Could be an electrical problem, very likely could also be a collapsed catalytic converter or a blocked/clogged exhaust system.
What is dimmer switch?
Usually a switch will only let you choose between ON and OFF, but a dimmer switch will let you change between Brighter or Darker.
Why would the windshield wipers on a 1991 Mercedes Benz 190e start by itself and not stop?
It is possible that your wiper switch is bad. The switch can be cleaned with an aerosol switch cleaner if that does not work then replace it. Pls let me know how it goes Regards Ehi
When I turn the key to start my 1990 Honda Accord it it turns over but As soon as I let the key go to the run position it just stops Do you have a diagnosis Is it the ignition switch?
The engine should run when you let the key go. The switch is most likely bad and will need to be replaced.
What causes engine to stall when let off clutch lt133?
I would start by checking to see if your operator presence switch is still working properly. Located under the seat, this switch is designed to shut the tractor down if the operator were to fall off the tractor suddenly. The clutch on your tractor would bypass that switch until the clutch was let out.
How does push to make switch work?
Push-To-Make switch is a switch in which pressure is applied to the switch for it to let the electricl current flow through.
What causes the rattle at engine start up and switch off. Citroen Picasso 1.6 hdi 2006?
tell me the mileage and i will let you know about the rattle
