I would start by checking to see if your operator presence switch is still working properly. Located under the seat, this switch is designed to shut the tractor down if the operator were to fall off the tractor suddenly. The clutch on your tractor would bypass that switch until the clutch was let out.
clutch
Is your clutch bad or wearing out ?
bad driving technique a clutch fault a misfire in the engine and having your bite point too high or releasing the clutch to quik
Downshift. Allowing or operating the clutch to make it slip causes friction which causes heat which causes premature wear to clutch parts which causes unnecessary repair bills.
Technically, it never touches the flywheel - the clutch disc does. You can stop the flywheel (stall-out the engine) by engaging the clutch in gear with the brakes firmly applied.
If the vehicle has an automatic transmission, then the torque converter clutch is probably sticking. The clutch is controlled by a solenoid, that moves it back and fourth. The clutch material can get stuck to the inside of the converter and stall the engine. Have the transmission flushed, and if the problem persists, then have the solenoid replaced.
rapid release of the cluth pedal. When stationary can cause a car to stall. When on the move can restart an engine, as in bump starting.
Dirty fuel filter
to much of it can stop our system
The revs jump up because when the clutch is pulled in the engine gets disconnected from the wheels. This means that it no longer has to move the weight of the car and it's driver so the engine gets more gas and floods
It is when the clutch will not hold. Like you can be driving up a hill and you can rev the engine with no increase in road speed. With the park brake set hard, the car should stall if you attempt to drive off. If you have the clutch out in first gear and the engine can still run and the car isn't moving, the clutch is slipping.
There are several reasons an engine may stall while driving, here are three.The fuel tank is empty and the engine is starved of fuel.Not enough power to climb a hill causing a stall.Faulty or damp electronics on a petrol engine can also cause a stall.