answersLogoWhite

0

It is when the clutch will not hold. Like you can be driving up a hill and you can rev the engine with no increase in road speed. With the park brake set hard, the car should stall if you attempt to drive off. If you have the clutch out in first gear and the engine can still run and the car isn't moving, the clutch is slipping.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

State three reasons for fitting a clutch?

Clutch judder, clutch slip, worn out!


Will oiling clutch on ac compressor help?

Oiling the a/c clutch will cause the clutch to slip and burn up........


Vauxhall zafira clutch slip?

my zafira clutch slipps in first gear after pulling away


How do you do a wheelie on a ATV?

use the clutch slip method


When will a clutch slip?

When it's worn out. When it's badly adjusted. When you keep your foot lightly on the clutch pedal.


Why would a brand new clutch slip?

Possibly the clutch was installed facing the wrong way, or the clutch has not had enough time to properly seat.


What causes clutch slip?

Clutch Slip can be caused by a couple of things but the main causes include a worn clutch plate, oil contamination on the friction plate itself, insufficient free-play and finally worn or seized operating mechanism.


How do you get round a corner fast on a motocross bike?

Slip the clutch.


How do you adjust the slip clutch on a john deere 506 brush cutter?

To adjust the slip clutch on a John Deere 506 brush cutter, first ensure the machine is turned off and safely secured. Locate the slip clutch assembly, typically found on the gearbox or drive shaft. Loosen the bolts on the slip clutch to relieve tension, then adjust the spring tension by tightening or loosening the nuts until you achieve the desired slip engagement. Finally, recheck the adjustment by reassembling and testing the cutter under load conditions.


Is there a recall on Chevy trail blazers fan clutch?

I have a 2002 Chevrolet trail blazer the slip clutch is out was there a recall on them?


Why does my Honda trx 450r run like the clutch is engaged when it's not?

Sounds like clutch slip. Either the clutch springs need adjusting or the clutch plates are worn out.


Why would a clutch smoke?

Because it is starting to slip and is ready to burn out.