Try looking at your fusible link that is connected to the battery, if it is 'blown' you will not get power to anything.
it depends on which battery you want and to put it in it cost nothing just a lil manual labor taking two cables off and taking the other battery out and put the new one in and put the cables back on
dead battery or try taking the battery terminals off and cleaning the terminals and battery cables with a wire brush and rehook.
Possibly the connection at the battery. Corrosion between the cable and the battery. The jumper cables are only connected to the cable and nothing is getting through from the battery in the car. Sure you have connection at both ends of the cables. It may not be the battery, starter may be bad or if the cables are badly corroded, the corrosion can work down the cable inside of the insulation and that will make them not work.
Sounds like a dead battery. Possible the battery cables just need to be cleaned and tightened. Try turning on the head lights. If they don't come on, your battery is definitely dead. If they do, try cleaning and tightening the battery cables.
You can purchase battery cables online for a low price. A good place to find these is at discount marine supplies. They carry battery cables and are discounted, too.
nothing will happen it will just send a charge of electric current to the end that isn't connected to the battery. hope i helped you sincerely, Blake
Disconnect the Regal battery cables. Find the battery clamp then remove it. Lift the battery out, then put the new one in. install the clamp, then connect the battery cables.
disconnect the battery cables. find the battery clamp and remove it. Lift the battery out, then set then new one in place. Install the clamp, then connect the battery cables.
When using battery cables to start a car, once it has started is there a procedure when removing the cables from the running car?
THe battery is under the back seat so you have to TAke all theose cables out
Just connect the battery to the motorcycle battery cables with jumper cables and then start it.
Take both cables off. Remove old battery. Put new battery in. Put cables back on.