I had the same problem on my pt i changed the assy for the Fog lights and turn signal i guess after a while this part goes bad pick up at the dealer for about 89.00 i think was a while ago fix the problem lights not staying on this part is easy to change only two or three screws holding plastic around the part need to remove first and then can access the part you need to take the ice cube off old part and reuse it on new part does not come on the new part this is for the turn signals without your signals will not work very simple to replace Good luck Bob
light is burned out
Throttle position sensor signal does not agree with manifold pressure sensor signal.
signal lights not working.
The fog light switch is on the end of the turn signal switch. Just pull the end of the turn signal switch and the fog lights will come on. (Turn signal switch and fog light switch are one assembly)
There are separate fuses for trailer signal lights in main fuse panel
either dimmer switch or blown fuse If you are saying that the tail brake lights are working but the third brake light is not....It may be a defective turn signal switch in the steering column.
The Range sensor inside the transmission (on the valve body) sends a signal to the trans computer(tcm) about gear position. The TCM then sends that signal to the TIPM (under hood fuse box) and it turns the lights on.The Range sensor inside the transmission (on the valve body) sends a signal to the trans computer(tcm) about gear position. The TCM then sends that signal to the TIPM (under hood fuse box) and it turns the lights on.
A mis-wiring or short circuit somewhere between the controls, fusebox and lights.
you need to change the flasher can for the signal lights
POSSIBLY A BADGROUND
you need to buy a signal lights relay
Turn signal indicators are lights. The flash to tell you, or indicate, that a turn signal is on, and which way the lights are flashing.