Possible bad starter motor or solenoid. Possible locked up motor (did you run it out of oil?) Possible bad ignition switch. Check all the fuses with a test light.
check igntion coils
First of all is the lights working in the car? (over head lights or any kind of lights) If your not getting anything at all (no lights) then you should check the battery. If the lights are working then I would check your starter. Most of the time if you take the battery somewhere to get checked they will do it for free. So I would start there. Did you try to get a jump to see if that would start it? Hope this helped some.
Needs a new battery.
AnswerI would start with the bulbs, make sure they are good and that they have power going to them. If there is no power at the bulb the problem is either your headlight switch or the dimmer switch.I would start with the headlight switch.And I would start with the fusesSee "Related Questions" below for more
I have run into this before on other makes of cars and it was the altenator. If you can get the car to a parts house like auto zone they can sometimes test them for you for free.
did you try ignition coil, igntion pick up coil. igntion control module. i would bet it's one of the three
that sounds like i ground in the bake by the lights or if it has a trailer plug i would start their
this sounds like a fuse or 2. that's where i would start.
sometimes the head lights and tail lights may be fused separately,check your fuses.you could have a bad ground.thats just two places to start.
Christmas lights clip art would become available in November. It becomes available during this time because people start preparing for Christmas during this time.
try hitting under your steeing column where your key for your ignition goes in and see if anylights flicker or change with key in on position, if they do, then i would suspect ignitoin switch faulty. recommend remove and replace igntion switch. good luck.
no, usually it will be a fuse. a battery would simply dim the lights to beyond usefulness, and if it gets too low, the pcm may start killing unneeded components.