The transformer that feeds your house is a center tapped transformer. Primary 7200, Secondary 240. The 240 volt secondary is center tapped to give you 120 volts on either side of the tap. Hence house voltage is 120 / 240 volts.
Center tapped transformers are used in North America to be able to use two voltages from the transformers secondary. It is known as a three wire system. Appliances circuits that utilize 240 volts and appliances that use 120 volts can be supplied from one transformer. The transformers secondary is center tapped and grounded. This allows the 240 volt winding L1 - L2 to produce 120 volts from one leg of the winding to ground L1 - N and the second half of the winding 120 volts from N - L2. <<>> Center tapped transformers are used anywhere world wide where ever they were designed to be used. There is nothing particular to a center tapped transformer that makes it more or less suitable for use in North America.
You can if done carefully. The neutral of one transformer must be set up to be at the positive voltage of the other transformer. This might require an intermediate step transformer that is center tapped (so three instead of 2 transformers).
The center tapped full wave rectifier depends on two similar windings, each 180 degrees out of phase with respect to each other. You are only going to get that with a center tapped winding. Without the center tap, you need four diodes.
This is a system whereby the primaries of distribution transformers form a closed loop. The distributors are tapped from different points of feeder througg distribution transformers... Vspyce naani!
well when you see on basis of output voltage the centre tapped transformers is .
No. For a full wave rectifier, you need two diodes and a center tapped secondary, or you need four diodes and a non-center tapped secondary.
Transformers can be used in either step-up mode or step down mode, they are just as efficent connected either way. Most large transformers have percentage "taps" to allow voltage corrections up or down by about 15%.
diamond
Yes....what about them? They are common items.
32 volts of course. But the real difference is the way the power company has "tapped" their supply step down transformers.
An ordinary transformer has two input/output terminals but a center tapped transformer has 2 input and 3 output terminals. One is taken from the center for a ground connection. This causes it to get 50% of the actual value. And ordinary transformer contains 2 windings. An autotransformer has one.
There are many different types of transformers used in industry. They include polyphase, capacitor voltage, and resonant transformers.