There are a total of four oxygen sensors ...This is a dual exhaust motor. The 2 before the catalytic converter are a almost impossible to get to . They are located between the firewall and the exhaust pipe near the manifolds. There are 2 more after the catalytic converter. They are at about a 45 degree angle so you have to either get the car on a lift or crawl all the way under and look near the top of each pipe to see them. I happened to see the leads and followed them to the O2 sensors. Word of advice.. run the motor at least 30 or so minutes and work on them immediately after shutting it off. This will help expand the fitting they are screwed into that will make it somewhat easier to break loose. Your going to need a breaker bar, 2 men and a small boy to get them out though... lol
A 1997 Ford Crown Victoria engine is fuel injected so there is no carburetor
In a 1997 Ford Crown Victoria : Fuse ( # 16 ) is a 20 amp fuse for the cigarette lighter
The 1997 Ford Crown Victoria OBD 2 port is located under driver side dash next to center console
In the fuel tank.
It's in the fuel tank.
Yes
Located under the vehicle, in front of the fuel tank.
There are 4. Two before the cats and two after.
Could be on the inner fender - follow the + battery cable
Are they both 4.6 L ?
Yes.
No.