0
Where are the battery cables connected to a 1997 Chevy van motor?
Wiki User
∙ 12y ago
The positive cable goes to the starter.
The negative cable bolts to the engine block.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you close your trunk if the battery is dead on a 95 sedan deville?
connect another cars battery with jumper cables. Will power the trunk motor, and allow it to be closed once cables are connected ( PROPERLY ). You might even be able to jump start car. Good luck
What is the fan is connected to on a Chevy s-10 motor?
what is the bracket that the fan is connected to on a Chevy 2.2
Tercel Toyota starting problems?
I have a 96 tercel and it stopped run while I was driving it, the problem was bad battery cables and the motor would not trun and the lights on the dish board would dim when the key was truned, lastly the cables connected to the battery had alot of white "stuff" all over them. Cables changed end of story car starts fine now.
Why would a car click when trying to jump start it?
The battery voltage is not high enough to start the car. The clicking is the solenoid trying to get enough power to activate the started motor. Try leaving the cables connected longer or try to get a better connection on the cables.
How do you connect a battery on a tractor?
1. Locate the tractor battery cables. 2. Follow each cable to where it connects to the tractor. One cable will be connected/attached to the tractor chassis/frame. The other cable will be connected/attached to the tractor starter motor. If you don't find this to be true, then discontinue this procedure now. 3. Connect the unconnected end of the cable that is connected to the starter motor to the "+" or "pos" battery post. 4. Connect the unconnected end of the other cable that is connected to the tractor chassis/frame to the "-" or "neg" battery post. 5. Snugly tighten the post connector nuts to ensure a firm/stable electrical connection. Done. Your battery is now connected to your tractor properly.
How do you connect motor from battery?
There are two circuits on the battery and motor. One wire is take which have four ends. The wire is connected on the desired circuits.
When you connected a voltmeter across a battery it read 6 volts When a connected a motor to the battery and switched on the reading dropped a lot Why?
i think it is because some energy is being lost throug the motor's consumption.
Can a diagram for two 12V deep cycle motor home batteries connected to output 12V be supplied?
You just connect them in Parallel. Two 12 volt batteries connected in parallel will output 12 volts. Two connected in Series will output 24 volts. Just connect the negative terminal on the first battery to the negative on the second battery. Then connect the positive terminal on first battery to the positive on the second battery. Connect the cables to the second battery, positive to positive and negative to negative. Click the link for a diagram.
Can a 350 vortex motor start if ground is not connected to the battery?
Engine ground can find many paths to the battery, but if NOTHING is connected to the negative post... no, it won't start.
Where is the blower motor relay on a 2000 Chevy Silverado?
the blower motor relay is located next to the blower motor it is connected to the motor by a purple and black wires
A new starternew battery good cables started yesterday but not today Starter motor will not turn Is it possible security system fault?
Could be a short in the wiring of the actual starter motor!! The starter motor is the first piece of electrical equipment after the battery.
Physical location of engine starter?
Answerusually on the underside of the motor where the motor meets the transmission.Physically follow the positive battery cable from the battery. In most vehicles the other end of the positive battery cable is connected to the starter.
