answersLogoWhite

0

Where are the drain plugs on the pump for salt water pool?

Updated: 8/21/2019
User Avatar

Wiki User

10y ago

Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Where are the drain plugs on the pump for salt water pool?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where are the water drain plugs on a 2000 mb sports 210 with the PCM Apex 5.7L motor?

Hi there, A lot of the bigger boats do not have drain plugs. The bilge pump is used to pump the water out. Hope this helps.


Is it normal for the pool pump to fill up with water while the pool is still filling up?

Certainly, if the pump is running. The primary pump intake is the main drain at the deepest part of the pool.


How do you drain water out of a pool?

If it is a vinyl liner pool you have to use a submersible pump. You can get a small one for right at $100.


How long does it normally take to drain the water from the pump when closing an in ground pool for the winter?

Draining the water from the "pump" (I'm assuming you mean the filter) should only take a few minutes. How long it would take to drain the water in the pool down to the winterization level would depend on the size of your pool and the pump you are using.


How do you remove water from an above ground pool?

If there is no drain plug then you can use a sump pump.


How can you treat a pool and clear the water up without pump operation?

Drain it and refill it


What will keep pool pump from sucking water from pool?

The pool pump does suck the water from the pool. Then it goes thru the filter and (if you use have the following) thru the heater and chlorinator then back into the pool. So - nothing will keep it from sucking water from the pool - but that's a good thing. Now - if you set the valve to a different setting - then it might actually send the water to a waste line - maybe that's what you meant. If that's the case -then the pool pump will eventually drain your whole pool if you have it set to get the water from the bottom drain (another valve).


How do you drain all the water in pool?

You can hire a pump from your local hire shop or purchase a submersible one


What is a bilge pump on a boat?

A "bilge pump" is not automatically on a boat. Every boat does however have a bilge area. It is the area in a boat's hull where water collects. This area is seriously recommended to have a "bilge pump" in it on every boat to pump the water out of this area while on the water. Bilge's have drain plugs on the back of the boat for when you take it out of the water to fully drain it.


What type of pump do you need to drain 24' dia x 4' deep above ground pool?

You could use your pool pump. or get a submersible pump. it is also not difficult to siphon an above ground pool with a pool vacuum hose. all you need is somewhere to run the water to.


How fast can a Submersible pump drain a pool?

Depends on the size of the pump However an average sise pump takes about 5 hours on an ave pool


If you have an inground gunite pool that was drained using the pump why can't you develop suction to drain it out now that there is only a bit in the bottom?

Most electric pumps have a guard at the bottom to prevent leaves and such from getting into the pump. Unfortunately, you need to have usually about 1/2" to 1" of water in the pool for the pump to work. I would suggest trying to drain the remaining water with a hose.