Want this question answered?
Every Hyundai i have seen does not have adjusting screws as such, rather slides where they mount to the body. simpley loosen and adjust then tighten
You can adjusts the headlight by turning the headlight adjustment screws. The adjustment screws are on each side of the headlight.
Each headlight has two adjusting screws. The adjusting screws are on the top and bottom of the headlight. Adjusts the headlight by turning the adjustment screws.
The 1998 Toyota headlight have two adjustment screws. There is an adjustment screw on the top and bottom of the headlight. Turn the screws to adjust the headlight.
There are adjusting screws on the top and sides to adjust them. I perfer to get on a dark road at night and adjust them how I want them being careful not to blind the oncomming traffic. There is a hole in the frame right above the hood, the screw to adjust the angle of the light is inside the hole. I believe a small Phillips screwdriver will do the trick. Make sure you are on level ground and facing a wall (garage works well) to adjust both lights to the same angle.
Turn the screws to adjust the headlight.32 psihow
there are two screws on each side of car above each headlight the outer screws adjust the up or down of the headlight the screw that's in the middle adjust side to side motion of the headlight there is an level when they are set right the bubble should be centered
The are adjustment screws next to the headlight housings. To adjust the headlights either loosen or tight the screws. This will either raise or lower the headlight unit.
There are two adjustment screws at 7 o'clock and 5 o'clock on the headlamp. Turning them will adjust the light.
To adjust the headlight assembly on a 2002 Montana Van you will need to loosen the side adjuster screws located to the left and right of the headlight. With the lights on use a garage door or solid foundation to see if the lights are level. Once you have the headlight in a desired position tighten the adjuster screws to secure the light in place.
The dash on a Hyundai Elantra is held on by several mounting screws. Remove all the screws found underneath plastic covers, as well as underneath the dash. Gently pull the dashboard towards the cabin and remove any attached sensors.
You can find adjusting screws on the back side of each headlight. The screws are facing the engine and can be accessed only if the hood is open.