0
most o2 sensors are located on the exhaust manifold or just below on the pipes itself ,but mainly depends on the engine.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How many Oxygen sensors does a 1998 S10 blazer have?
A 1998 Chevy S10 Blazer has a total of two oxygen sensors. One is used for the upstream and one for the downstream.
Where is the fuse block for the oxygen sensors on a 1999 Chevy s10?
It does not have a fuse sorry.
Where is the oxygen sensor on a 1999 Chevy s10 4.3?
That vehicle has several oxygen sensors and they are all threaded into the exhaust at various points.
Where are the oxygen sensors located on the 1998 Chevy s10 blazer?
They are all threaded into the exhaust system at various points.
How can you check sensors on a 1995 s10 Chevy pickup?
What sensors? Be specific.
Where are the oxygen sensors on 2001 Chevy s10?
They are all threaded into the exhaust system at various points. Best reached from underneath.
Location of oxygen sensor 03 Chevy s10?
You have several O2 sensors on that vehicle and they are all threaded into the exhaust system at various points.
Where is the oxygen sensor located on a 86 Chevy S10 2.8 engine?
All O2 sensors are threaded into the exhaust system at various points.
How do you change 1998 s10 oxygen sensors?
The oxygen sensors on a 1998 Chevrolet S10 are changed by disconnecting the lead wire and unscrewing them from the exhaust manifold. New sensors are then screwed into place and the wires reattached.
Where is the location of the oxygen sensor on a Chevy S10 Pickup V6 4.3L?
There are four sensors in total. One on each downpipe, one just in front of the cat and one after the cat.
Your 98 Chevy s10 fails smog test have replaced everything but egr valve and oxygen sensor what else can you do?
A faulty EGR valve can cause a 98 Chevy to fail a smog test. The oxygen sensors should also be tested as they can also cause a 98 Chevy to fail a smog test.
Where is oxgyen sensor on 1995 Chevy S-10?
Where is oxygen sensor on 4.3 liter 1995 Chevy S10. All O2 sensors are threaded into the exhaust system at various points, and you probably have more than one sensor.
