there are 3 in the front and 3 in the back if its a 6cyl.
i would like to know what would cause the miss firing in Chevy Malibu
Remove the spark plug wires from your 2004 Chevy Malibu spark plugs. Remove the old spark plugs with a 5/8 deep well socket, by turning the socket to the left. Reverse the process to install the new spark plugs.
did you gap your plugs right!!
The spark plugs for any Chevy cobalt are located under the 4 wires that go into the center top of the motor, each one is evenly spread out into a line. Unplug those wires and below them are the spark plugs
Follow the spark plug wires, they will lead you right to them.
it is located to the right of the coils and plug wires on top of engine. facing it! it is a round cylinder shape. with wires to it on the top of it.
They should be on the side of the cylinder head. they will have plug wires ging to them.
Cylinder head(s) Follow the wires until the end.
The Spark Plugs are located under the resonator box in the center of the engine (its the rectangular black box on top of the engine)
Spark plugs and wires
To change the spark plugs on a 2000 Malibu, you need to get a spark plug socket with a u-joint in order to access the plugs on the firewall side of the engine. The plugs up front are easy to get at, and don't require anything special. Word of warning, if your Malibu has relitivley high mileage on it (80,000+) and it still has the factory plug wires, there is a good chance that they will break on you when you have to pry them off of the plugs, go ahead and replace the plug wires when you replace the plugs.
4.3? Follow the spark plug wires from the spark plugs, they will lead you right to the distributor.
If it is the 2.2 ecotec engine, it is located on the spark plug cover withe ecotec logo on it. It is a little square with wires and heat fins on it.
A local garage is charging me $278-ish for plugs and wires on a 2007 Chevy Equinox today.
Any good quality plug and wire set will be fine for this car. There is really no need to buy real expensive plugs and wires for this vehicle. Accel makes good plugs and wires.
They are in the heads where the exhaust manifolds are bolted to the heads. The plugs have rubber wires hooked to the ends of them.
There are 4 spark plugs, It's a 4 cylinder so there are 4 plugs. Should be under a panel on top of the engine, shouldn't be any wires just plugs.
Change the plugs and plug wires at around 100,000 miles or earlier if you detect a miss or loss in performance of mileage.
Follow the spark plug wires.... :)
those particular wires and plugs are located in the engine compartment under the hood of that Lincoln the spark plugs are located on both sides of the engine block about half way down the wires are connected to the spark plugs and then run all the way to the coil/distributer whatever that particular model has good luck
when you look at the top of the motor you will see four black plastic caps with wires going to them you need to take them off and you will need a long spark plug remover to get to the spark plugs but that is were they are located
unplug the wires and swap, its very simple. plugs are located on the left side of the engine, to the right of the battery.
remove 4 bolts on top of motor and the spark plugs are behind that.Doesnt use spark plug wires or distributor.change fuel filter, its behind the fuel tank.