0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Is there a diagram of the rear brake shoes of a 1999 Saturn SC1?
Yes, there is a diagram of the rear brake shoes of the 1999 Saturn SC1. It is found in the cars maintenance or repair manual.
Can you cut off rear brake line?
You can cutoff the rear brake line. You will no longer have rear brakes and the fluid will leak out. It is not recommended that can't off the rear brake line, without replacing it.
Do 1998 Saturn's have brakes shoes or disc rear brakes?
1998 GM Saturn (all models) have rear brake shoes
How do you replace rear brake drums for 1999 Chevy Venture?
i was wondering how to change rear brake drums for 1999 Chevy venture
Is there a adjustment for rear brake shoes on a 1994 Saturn SL1?
Yes there is.
What is the valve for on your Mazda E2200 rear brake line?
the valve on the rear brake line is to limit brake force on the rear ie.loaded full pressure,empty reduced pressure to stop the rear brakes locking.
How do you change the rear drivers side break line on a 1999 Chevy silverado above the gas tank.?
The brake line will have a retaining nut on each end of the line. Loosen the retaining nuts. Reverse the process to install the new brake line.
How do you fix a leak in the brake line at the rear drum of a 1999 Honda crv?
There is no safe way to repair a broken or leaking brake line. The line or tubing that is leaking must be replaced or a new piece of tube, spliced into the line with fittings, to replace the leaking area.
Can a 1999 Saturn SL1 rear passenger side door be used on a 1997 Saturn SL1?
yes
Change rear drum brakes on a 1999 Saturn SL2?
Are you asking how to??
What are rear speaker size for a 1999 Saturn SC1?
6 and a halfs
How do you replace rear brake calipers on a 1995 Saturn SC2?
The rear calipers have not to much difficult than the front. -Remove the brake line being sure not to loose the bolt and washers. Be sure to have a bucket to catch the brake fluid. -Remove the parking brake line. Do this by pushing the tabs (two of them) in and pushing the line back through the bracket. -Remove the caliper pins. -Remove the caliper Installation is the reverse. Be sure to bleed ALL the brakes after the new caliper is in. Start in the passenger side rear, driver side rear, passenger side front, and then finally the driverside front.
