answersLogoWhite

0


Best Answer

The brake line will have a retaining nut on each end of the line. Loosen the retaining nuts. Reverse the process to install the new brake line.

User Avatar

Wiki User

9y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you change the rear drivers side break line on a 1999 Chevy silverado above the gas tank.?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

A Fuse Box Diagram 1987 Chevy silverado?

under drivers side dash panel ,up above emergency brake


Does a 1995 Chevy Silverado have an obd2 port?

Yes, it is under the edge of the dash just above your knees when sitting in the drivers set.


Where is the coolant temperature sensor on a 2001 Chevy Silverado?

It is located on the front edge of the drivers side head, right above the exhaust manifold.


Where is the sig lite flasher on 92' Chevy Silverado?

The signal light flasher on a 1992 Chevy Silverado is under the dash. It is on the driver's side just above the brake pedal.


Where is the coolant sensor on a 95 Chevy silverado located?

The 1995 Chevy Silverado coolant sensor is located on the front of the engine. The coolant sensor will be a few inches above the thermostat housing.


Where is the oil filter on a2005 Chevy Silverado?

on the left side of motor above front driveshaft


Where is the flasher located on a 1994 Chevy Cavalier?

Above the drivers foot pedals


Where is the pcm 2004 Chevy Silverado?

It is located in the engine bay, above the driver's side frame rail and below the battery.


Where is AC clutch relay located on 1994 Chevy Silverado?

above the a/c and heater housing, behind the glove box , right side dash


Where is the internal fuse panel on a 1988 Chevy Blazer K5 Silverado - I need to change the cigarette lighter and internal cab light fuses Thanks?

the fuse block on that should be located under the dash right above your right foot.


Where is the obd2 plug found in your 1998 Chevy blazer?

Under dash, drivers side, above e-brake pedal.


Where is the evap canister located in the 2000 Chevy S-10?

Above the drivers side rear axle, attached to the frame.