answersLogoWhite

0


Best Answer

One ( BCM body control module) is located on the passenger side to the Left of the glove box. Mounted on the metal sidewall. Remove plastic dash panel with ac air outlets. Locate the screw on an oblong hole and remove. pull back carpet and insulation and pull on the box( abt 6x8 inches square), then down. There are 2 or

3 elect sockets connected. Hard to get out hard to replace.

#2 ECM/PTC power train control module. Located under the air filter box. Remove box and then one screw that holes the large connector 60 pins. 2 screws hold the PTC onto the chassis

If either one of these bad there might be other modules bad also

You also have abs, airbag, HVAC,

User Avatar

Wiki User

10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where are the two computers located on 1994 Chrysler new yorker?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the radiator located on a 1994 Chrysler New Yorker?

It is between the engine and the front bumper.


Where is the carburetor on a 1994 Chrysler New Yorker?

A 1994 New Yorker is fuel injected and does not have a carburetor.


Where is the fuel pump located on a 1994 Chrysler new yorker?

Inside the fuel tank. The LH body New Yorker has an access panel in the trunk.


Where is the AC condenser drain located in a 1994 Chrysler New Yorker?

in the front passenger side of the motor


Where is the alarm located in a 1994 Chrysler New Yorker?

passengers side front corner under hood


Where is the crankshaft position sensor located on a 1994 Chrysler new yorker 3.5 liter?

It is located back by the belhouseing on the left side.


Where is the thermostat on a 1994 Chrysler New Yorker?

The thermostat is located under the housing where the upper radiator hose hooks to the engine.


Where is the fuel pump relay switch located in a 1994 Chrysler New Yorker?

The relay is in the fuse box under the hood.


How do you disable the alarm on a 1994 Chrysler new yorker?

The easiest way to disable your 1994 Chrysler New Yorker alarm is to remove the alarm fuse. The alarm fuse can be found in the fuse box.


Where is the fuel kill switch for a 1994 Chrysler New Yorker?

Chrysler does not have inertia or kill switches.


Where is the alarm kill switch on a 1994 Chrysler new yorker?

Chrysler does not have reset or kill switches.


Where is the Trasmission Speed Sensor Located at Chrysler New yorker 1994?

i think what your looking for is just above the back up/ netural switch