eBay or forum vendors
Yes, but the HID low beam headlight on the 2003 model was an option offered at time of original purchase of the car. However, one can add an aftermarket HID light conversion kit to a non-HID 350z after doing some research.
Aftermarket HID's are illegal in ANY state. Period.
If you're smart, you don't buy aftermarket headlamps at all; they give much worse performance than new genuine (factory/original/stock) headlamps. And "HID kits" are widely available, but they are (all) illegal and dangerous. The only legitimate/safe/legal HID conversion is to install complete HID headlamp assemblies designed, built, tested, and certified as such. Halogen headlamps must use halogen bulbs.
You must buy the conversion kit unless you already have hid installed.
Don't do it. "HID kits" are widely available, but they are (all) illegal and dangerous. The only legitimate/safe/legal HID conversion is to install complete HID headlamp assemblies designed, built, tested, and certified as such. Halogen headlamps mustuse halogen bulbs. If you're smart, you don't use aftermarket headlamps, either. Most aftermarket headlamps give much worse performance than new genuine (factory/original/stock) headlamps.
There are two ways to do this:Replace the entire light unit with a HID light unit compatible with the car, if one is available.Use an aftermarket HID conversion that fits standard bulb sockets, and adds HID bulbs and a ballast unit.HID bulbs require a ballast unit to generate the high voltages required, so are not a direct replacement. In most HID kits, the power can be taken from the existing lighting power supply, so the lights operate as normal.HID conversion kits are not road legal in some countries.
Yes, HID lights need a ballast.
An HID Xenon conversion kit is an aftermarket automobile headlight replacement system that will let a car owner swap out standard halogen headlights for LED headlights.
To install aftermarket HID headlights on an Infiniti G35 coupe, start by disconnecting the battery to ensure safety. Remove the headlight assembly by unscrewing the bolts and disconnecting the wiring harness. Install the HID bulbs into the headlight housing, connect the ballasts according to the manufacturer's instructions, and secure them in place. Finally, reassemble the headlight assembly, reconnect the battery, and test the lights to ensure proper functionality.
no
When the LED light on an aftermarket alarm stays on, it means that the alarm is active. The light generally shows that the alarm status is "ready."
The wattage depends on the size of the growing area. It also depends on whether HID is the main source of light or if it supplements sunlight. And it also depends on the types of plants. 150/175 watts if HID lights 2'x2' growing area, and HID and sun light 3'x3' 250 watts if HID 3'x3', HID and sun 4'x4' 400/430 watts if HID 4'x4', HID and sun 6'x6' 600 watts if HID 6'x6', HID and sun 8'x8' 1000 watts if HID 8'x8', HID and sun 10'x10'