I was searching for that switch arm also, but only found that everyone who has a Lexmark x3470 has or will have this problem. Replacing a part that was designed to fail will fail again and is not worth anymore time or money, get a better printer. Sad to say but it is not just Lexmark that engineers there product to last through warranty and break.
The waste toner box in the Lexmark X544 printer is located inside the printer, typically accessible by opening the front cover. Once the front cover is open, you may need to remove the toner cartridge to reach the waste toner box. It's essential to follow the printer's user manual for specific instructions on safely removing and replacing the waste toner box.
Every printer is different.
It could be the printer or the person that supplied the printer with the mistake.
Lexmark photo centre does a great job, then despeckle
With a Printer.
There can be an issue with the printer itself if the status of your printer reads "Printer in error state." Ensure that the printer is powered on and wired or wirelessly connected to your computer. Make sure that it has enough paper or ink, the cover is closed, and that the paper is not jammed.
YOu can use dot-matrix printer for carbone paper or a lazer printer with special label to cover the PIN such as PHS system from Otto Kunnecke
No cam sensor. Just a crank sensor on the bottom of the timing cover
The camshaft sensor is the same as the crankshaft sensor it is local on the passenger side of the valve cover . And going down to your crankshaft inside the timing belt cover
mainly a colonial printer would print books, newspapers, posters, anything. printing was a difficult process in which the printer would arrange letters on a printing press, cover them with ink, and, well, press.
To clear a paper jam in your X5495 printer, first turn off the printer and unplug it for safety. Open the printer cover and carefully remove any visible jammed paper from the paper path, taking care not to tear it. Check both the input and output trays as well as the rear access panel for any stuck paper. Once cleared, plug the printer back in, close the cover, and turn it on.
it is on the windshield behind the mirror..there is a black plastic cover behind the inside mirror, sensor is inside that cover..