The camshaft sensor is the same as the crankshaft sensor it is local on the passenger side
of the valve cover . And going down to your crankshaft inside the timing belt cover
The Camshaft sensor is located under the cap and rotor of the distributor. This is a common failure on the 2.4L engine due to oil leakage into the distributor. how is the camshaft sensor replaced on 1995 Nissan altima. what other considerations are there.
There is no cam sensor on the 1995 year engine. GM. did not use a cam sensor on that year.
Inside the distributor
That year did not have 1
Inside the distributor.
The 1995 Mitsubishi Eclipse crankshaft position sensor is located on the back of the engine. The crankshaft position sensor will be near the bottom of the engine cover.
The 1995 for Crown Victoria camshaft position sensor can be found on the back of the cylinder head. The camshaft position sensor will be labeled as such.
YesYes
The camshaft position sensor, which is located inside the distributor, is a pretty easy component to test on the 1992-1995 5.2L/5.9L Dodge Ram 1500/2500 pickup.
if it is a 3.5 like mine it is located right next to the thermostat and a 10mm wrench and 5 minutes
On a 1995 Chevy S10 pickup, the camshaft position sensor is typically located on the front of the engine, near the timing cover, often near the camshaft gear. It may be positioned on the driver's side or passenger side, depending on the engine type. For precise identification, it's best to consult the vehicle's service manual or a repair guide specific to your engine configuration.
It is inside the distibutor.