0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the name of the mounting post on the Lincoln mark viii alternator?
alternator bracket
How do you replace the alternator mounting bracket on a 2003 Chevy S-10 2.2L?
very carefully
How do you replace alternator belt on 1998 Honda Civic?
The alternator belt on a 1998 Honda Civic is replaced by loosening the mounting bracket, disconnecting the wiring harness, and slipping the belt off the pulley. The alternator is then unbolted, removed, and a new unit put in place.
How to replace the alternator on a 1993 Dodge Grand Caravan fully loaded?
3.3L and 3.8L Engines The 3.3L and 3.8L engines were equipped with the Nippondenso alternators. 1. Disconnect the negative battery cable. 2. Remove the alternator drive belt, by relieving the tension on the dynamic tensioner. 3. Loosen the nut on the support bracket at the exhaust manifold, do not remove it. 4. Remove the alternator tensioner/power steering bracket bolt. 5. Remove the tensioner stud nut and remove the tensioner. 6. Remove the alternator mounting bolts. 7. Remove the power steering reservoir from the mounting bracket, do not disconnect the hoses, and position it out of the way. 8. Remove the alternator support bracket bolts. Remove the intake plenum to alternator bracket bolt and remove the alternator support bracket from the engine. 9. Remove the alternator from the engine and disconnect the electrical leads. To install: 10. Install the alternator in position on the engine and connect the electrical leads. 11. Install the alternator support bracket, tighten the retaining bolts to 40 ft. lbs. (54 Nm). 12. Install the power steering reservoir on the mounting bracket. 13. Install the alternator mounting bolts, tighten the bolts to 40 ft. lbs. (54 Nm). 14. Install the tensioner and tensioner mounting stud. Install the retaining nut on the exhaust manifold. 15. Install the alternator belt, insert a 1/2 in. extension into the square hole in the tensioner and turn the tensioner. Tighten the tensioner bolt. 16. Connect the negative battery cable.
What size torx bolts are used on 1993 Buick roadmaster Wagon alternator mounting bracket?
They are either T40 or T45?
How do you replace ignition coil for 1984 Chevy Celebrity?
To replace the ignition coil: Unplug the wires from the coil, take note of how they come out so you can put them back. Unbolt the bracket from the intake manifold. The original coil is riveted to the mounting bracket, the new coil usually comes without the mounting bracket. Next cut the rivets off that hold the old coil to the mounting bracket. The new coil normally comes with bolts to hold it to the old bracket. Install the new coil to the mounting bracket then mount the bracket to the intake manifold. Plug the wires back in.
How do you replace the alternator on a 2000 Hyundai Elantra?
# Disconnect negative battery cable # Raise car and support it # Disconnect the wire harness from the alternator electrical connections # Loosen the alternator lower mounting bolts.Working from above loosen the upper adjustment lockbolt,back off the adjustment bolt swivel the alternator toward the engine and then release the drivebelt from the alternator pulley # Unscrew and remove the alternator upper and lower mounting bolts and washers then remove alternator from its mounting bracket
How do you replace an alternator in a VW Jetta?
Hi, if you are still looking. gas engine Jetta: remove negative battery cable. remove positive cable on alternator. remove blue wire on alternator. Loosen and remove mounting bracket (on top of alternator) be careful not to lose any of this bolt (very hard to find replacements). Remove alternator belt. REmove lower mounting bolt. Remove from engine. Reverse to install. All done. diesel Jetta: mounting bracket is on the bottom and engine mount is on the top. that's the only difference. same procedure. have fun!
Is the hard drive connected to a mounting bracket If so what type of screws secure the hard drive to the mounting bracket?
Is the hard drive connected to a mounting bracket? If so, what type of screws secure the hard drive to the mounting bracket
How do you replace the alternator on a 1995 Honda Civic?
To replace the alternator on a 1995 Honda Civic disconnect the battery. Disconnect the wiring from the alternator. Loosen the adjustment bracket so the belt has slack. Remove the alternator belt along with the mounting hardware. Pull the alternator and replace it.
How do you replace the hose at the top of the water pump on a 2000 dodge ram 1500?
You need to remove the ac compressor, alternator, and their mounting bracket.
How much will it cost you to fix the alternator in your 2000 bravada?
do it yourself it will be around 80-150 bucks. east fix take the belt off and remove the bolts from the mounting bracket and install new one
