In any Plumbing supply store, but not usually in hardware stores which generally stock up to 3/4 inch, not 1" or more.
Yes, first the Galvanized pipe has to be threaded with a standard thread for pipes, then you buy the correct female socket threaded plastic fitting, screw it onto the pipe using Thread pipe sealing tape, then glue your piping into the socket part of the plastic fitting, simple. Cheers.
1/2 inch for 1/2 inch pipe.
It depends on the size of PVC. For smaller PVC you can buy fittings that glue onto the PVC and allow a thread x barb fitting to be installed. For larger pipe you should get a brass compression fitting that clamps down on the PVC and adapts to a thread x barb fitting.
Most lumber yards should have it.
Buy a 1/2 inch female iron pipe angle stop with a 3/8 inch compression outlet.
Buy a 3" MECHANICAL COUPLING at any hardware or plumbing store. Made of rubber and has hose clamps.
Any plumbing supply and it comes in galvanized steel , black steel, Brass
Buy those isulated pipe covers that slip over the pipes the sponge type pipe fitting its not costly go to your nearest home center and just ask for an allternative to saving heat and they should help you.
That's going to depend on: -- the thickness of the pipe's walls -- the length of the piece you want to buy -- the material of which the pipe is composed -- where you buy it
Yes you can. From a fellow pipe smoker.
If it is vacuum a gauge oil filter. You have to buy a 3/8 pipe t fitting to fit the block and install both the sensor and the gauge tube on. Key on power wire to light it up.
america