You can find a 120V power cable at your local hardware store. Look in the section under extension cords.
One can find a 120V electric power cable in stores such as Lowe's or Home Depot. It can also be purchased online through the store websites or through sites like rakuten for a cheaper price.
You can use 120v 10a 125w cable projectors 110-240v power in India.
Power adaptors are readily available that plug into Australia's 240v outlets, converting to 120v. Find them in travel, luggage and electronics stores.
you dont go by voltage to determine wire size its amps you have to go by. 15A= 14GA 20A= 12GA 30A= 10GA and so on down the line. 120VA at 120V = 1A 14ga will be more than heavy enough. If you are replacing a power cord you can yse a 16 or 18ga cable. 120VA is a measure of power, not voltage. Thus, you need a cable capable of carrying 120/V amperes safely, where V is the voltage (usually 120V in North America).
No. The neon sign is fed by a step-up transformer. Primary side 120V, secondary side 7500V. If you applied 240 to the primary side you would get 15000 volts on the neon tube. A flash over and then nothing. If you can find a transformer from 120V to 240V or 240V to 120V then you are good to go. Connect 240V to 240V side and you will get 120V out the other, connect the 120V side to the neon sign and you should have light. Transformer should be at least 100va. This will give you an output of .83 amps at 120V
Difference_between_copper_and_bronze
To find the power will depend on the voltage the item uses. Assuming a 120 volt circuit divide the wattage by the voltage, this gives the amps used. 2000w / 120v = 16.67 amps. 1500w/ 120v = 12.5 amps used.
The APC 1500 has a standard power of 865 watts/1500 VA. The APC 1500 has an output of 120V and an output of 120v. The specifics of the model can be found on the official website.
yes
Input would be 120v at 60hz. Standard US wall power.
Due to the power required,you will need to runa dehumidifier using 120V power.
This fan is rated at 277 CFM using 120V of power.