One can find a 120V electric power cable in stores such as Lowe's or Home Depot. It can also be purchased online through the store websites or through sites like rakuten for a cheaper price.
No. The neon sign is fed by a step-up transformer. Primary side 120V, secondary side 7500V. If you applied 240 to the primary side you would get 15000 volts on the neon tube. A flash over and then nothing. If you can find a transformer from 120V to 240V or 240V to 120V then you are good to go. Connect 240V to 240V side and you will get 120V out the other, connect the 120V side to the neon sign and you should have light. Transformer should be at least 100va. This will give you an output of .83 amps at 120V
To calculate the fuse rating needed, use the formula: Fuse rating = (Power of appliance / Voltage of appliance) + 0.25. For the 2.5kW heater at 120V, the calculation is (2500W / 120V) + 0.25 = 20.83A. Therefore, you would use a 20A fuse for the 2.5kW heater at 120V.
If your electrical service is only 120 volts you have a problem. There is no way that you can connect a 240 volt cook top to that service. You have two options, one is to upgrade to a new 120/240 volt electrical service. Your other option is to find a 120 volt electrical cook top.
Fargo Electric in Buffalo may be able to help! You can also find some good deals online, at sites like siliconsolar.com. Good luck! I would suggest paying a visit to L. A. Woolley Electric, Inc. You will find the best deals on a cheap power converter online at Amazon.com.
The Mitsubishi LT-70 turntable requires a standard AC power supply rated at 110-120V and 60Hz. It is important to ensure that the power supply meets these specifications to avoid damaging the equipment.
You can find a 120V power cable at your local hardware store. Look in the section under extension cords.
Power adaptors are readily available that plug into Australia's 240v outlets, converting to 120v. Find them in travel, luggage and electronics stores.
find your electric Meter and you've found the point of entry, or depending on where the electric meter is in the building, you can trace the cable back from the meter to the point of entry.
You can find a cheap electric power washer on ebay.com or on amazon.com's marketplace section. You can try looking in your local craiglists.org section.
To find the power will depend on the voltage the item uses. Assuming a 120 volt circuit divide the wattage by the voltage, this gives the amps used. 2000w / 120v = 16.67 amps. 1500w/ 120v = 12.5 amps used.
No. The neon sign is fed by a step-up transformer. Primary side 120V, secondary side 7500V. If you applied 240 to the primary side you would get 15000 volts on the neon tube. A flash over and then nothing. If you can find a transformer from 120V to 240V or 240V to 120V then you are good to go. Connect 240V to 240V side and you will get 120V out the other, connect the 120V side to the neon sign and you should have light. Transformer should be at least 100va. This will give you an output of .83 amps at 120V
Difference_between_copper_and_bronze
Electric types are generally found in the power plant.
In the National Electric Code Book or in an Ugly's Electrical Reference book.
= Answering "http://wiki.answers.com/Q/How_do_you_find_the_fuse_for_the_1990_acuralegend_if_battry_is_not_charging-o-meter_cable_or_is_it_electric_If_electric_where_is_the_sensor_exactly" =
Yes you need a cable. It is called a 1/4 inch instrument cable. You can find them at all local music stores or my favorite www.musiciansfriend.com Yes you need a cable. It is called a 1/4 inch instrument cable. You can find them at all local music stores or my favorite www.musiciansfriend.com
You can find more information on electric power washers at Home Depot or Lowe's. Those stores have many books on the matter as well as classes to teach you how to use it.