local advance autoparts store they sell a kit comes with 3 sets i think you have to match up the old ones.
Rockauto.com has them and so does O'Reilly's auto parts A Chrysler dealer should be able to get them.
The linkage bushing is located under the Crowl grill. Remove wipers and grill.
Advanced Auto Sells a bushing kit
Broken linkage or bushing in the wiper system.
how you change the wiper linkage bushing requires you to take off the wiper blades and vent off the top off the dak there should be about 8-9 screws maybe less, then when the vent is removed, there will be a plastic vent with plastic clips, simply lift up one edge of vent it should just pop out the do the same with other clip, when vent is lifted up unplug the rubber tubing from spray nozzle then repeat with other tube, when plastic vent is removed you should be able to see the wiper linkage crank and wiper arms there you should see the bushing simply pull the wiper linkage and remove the bushing and replace.
You should be able to buy the linkage bushing from any auto parts store like AutoZone, O'Riely's or Pep-boys. If they do not have it in stock, they can probably order it for you. You could also buy it online.
Wiper linkage broken or disconnected? Bad wiper transmission? Wiper Bushing. I have an '03. The wipers are crap! One goes out, once fixed-BAM...other one stops!!
Diagram replacement linkage for wipers 2000 Nissan Xterra.
You have to remove the linkage from the wiper motor.
You might not have to replace the entire linkage. I went to Chrysler Part Dept. and picked up a bag of the nylon or plastic clips that goes on the ends of the linkage where it connects to the other moving parts. They just clip on to a stud and into a hole. (The right side wiper linkage came off where it hooks to the wiper arm. they get brittle and break apart after a few decades.) To get to them, remove the plastic panel that sets under the rear of the hood. Then remove a couple of plastic screens that cover the ends of the linkage. After some cuts and scrapes that result in about half a pint of blood loss, your wipers should work as good as new. P.S. My Lebaron was an 89. Hopefully they didn't change that much......
how do i repair 1997 nissan maxima wiper linkage
If one wants to replace a wiper linkage there are a few steps involved. Pull the wiper arm away from the windshield until the arm locks in vertical position. Unbolt the nut that holds the wiper arm to the linkage and pull the wiper arm off the linkage. Open the hood and unbolt the wiper motor and slide the motor off of the linkage. One then will remove the wiper linkage and install a new one.