call your local salvage yard... probally charge you like 10 dollars or so for one...
Clearly listed in the manual.
Behind the seat.
allright you are going to have to jack the car up on jackstands, and you will see the starter going on the side of the engine block.
Remember to reduce the size of the Jack to it's smallest dimensions before trying to fit it back in the holder. : )
yes you do. jack up under engine, put a block on jack so not to hurt engine, only put enough tension to re move left motor mount .then replace belt,put mount back on, lower jack, then check mount bolts fo tightness. 3.1 Chevy engine in 2000 Malibu!!
To change wheel cylinder on a 2000 Chevy Malibu, jack up the vehicle and remove the tires, brake drums and brake shoes. Spray the hydraulic line and fitting with CRC 5-56 and loosen hydraulic fitting. Remove the two mounting bolts and remove the wheel cylinder. Replace with new.
in the glove box
the fuel filter should be located under car in front of the fuel tank. dont forget jack stands and a small container for some drainage
You have to jack up the front end, and take off the front two tires. Check the tread wear. If its good your good to go!
The jack is located under the rear passenger side seat. The tool kit is located behind the rear drivers side seat.
where is the jack in a 2005 nissan murano
The tire jack is located in the rear inside of your Chevy blazer. The jack can be found in a side compartment.