A great place is ebay.com or your local salvage yard should be able to hook you up!
The deck is the surface to which you bolt the cylinder heads to.
The spoiler is bolted on and yes if you take it off there will be holes left in the deck lid.
book value of john deer 1987 420 with a60" deck
DuckTales - 1987 All Ducks on Deck 1-50 was released on: USA: 9 December 1987
best bet would be to not cut any wires at all. you can buy a wiring harness from wal mart and it costs maybe 15 bucks. the plug fits with the factory plug in the truck and all the wires that connect from this harness to your deck match as long as your deck isn't too old leave the factory plug in your truck it is alot easier and you wont have to worry about it shorting out...
Hooperman - 1987 Deck the Cell with Bars of Folly 1-11 was released on: USA: 23 December 1987
its the factory coax cable.
Stock rod length is 6.135 inches, unless it's a tall deck engine, in which case the rods are .400 longer (6.535), tall deck engines were used in big trucks like dump trucks and were usually 427 cu in, if you're talking about a pickup truck or a car it's most likely a short deck version. Deck height on a short deck big block Chevy is 9.800" from the center line of the crankshaft to the deck, deck height on a tall deck big block Chevy is 10.200" from the center line of the crankshaft to the deck.
your trunk lid
idk how to fill the void in 99 Tahoe on the bottom of the dash after i took out the disk player
two screws on the dash cluster one by the lighter and two underneath the botom dash fro there you can see the mouting bracket for the dek remove the 3 bolts and the deck should slide out
Have you removed the factory tape deck?