You can't assign an ip to a switch but you can add one to the interfaces......... like: for the management vlan (or any other vlan) Switch(config)#int vlan 1 Switch(config-if)#ip address {your ip address} {mask} Switch(config-if)#no shutdown any other port Switch(config)#int <fa, G, S> <interface number i.e. 0/0> Switch(config-if)#ip address {your ip address} {mask} Switch(config-if)#no shutdown and for a default gateway Switch#conf t Switch(config)#ip default-gateway {ip address}
It doesn't necessarily need and IP. Depends on whether it is a managed or unmanaged switch. For instance your switch would need an IP address in order to telnet to it.
Might be the IP switch or the elements gone out no way to find out without testing the switch
yes switch work on ip address.
If you want to find your IP address,visit Ip-details.com .
If you want to find your network IP address,visit Ip-details.com .
If you want to find your network IP address,visit Ip-details.com .
If you want to find your IP address,visit Ip-details.com .
I use Ip-details.com to find my IP address.
The Cisco switches I have seen don't have an IP address by default. You have to connect to the switch with a console cable - one that connects to the console port on the switch, and to the serial port on the computer - and do some initial configuration, including the IP address.The Cisco switches I have seen don't have an IP address by default. You have to connect to the switch with a console cable - one that connects to the console port on the switch, and to the serial port on the computer - and do some initial configuration, including the IP address.The Cisco switches I have seen don't have an IP address by default. You have to connect to the switch with a console cable - one that connects to the console port on the switch, and to the serial port on the computer - and do some initial configuration, including the IP address.The Cisco switches I have seen don't have an IP address by default. You have to connect to the switch with a console cable - one that connects to the console port on the switch, and to the serial port on the computer - and do some initial configuration, including the IP address.
A layer 2 switch may need an IP address if the operator wishes to be able to access it without a serial cable. With an IP address, the switch can be access from anywhere with a connection to the network or an Internet connection.
If you want to find IP address location,visit Ip-details.com .