Any music store that sells wind instruments will have it and you can also buy it online.
Your trumpet valve sticks because it is to dry if you want to fix it buy some valve oil undo the valves and put some along the metal piece.
Yes, but only rotory valve oil. Piston valve oil (used in trumpets) will damage the valves.
If you have a conventionally-made baritone horn, you should be able to unscrew the tops of the valves by turning counter-clockwise. After doing that, take them out and put some oil on them, as much as you deem necessary.
To apply valve oil to a trumpet, first unscrew the cap to the oil. Then uncrew the valve that is sticking. Twisting to the right will loosen it. Take the valve out of the slot, and wipe it dry. It may have pre-existing oils and spit on it. Next, apply a THIN layer of oil to the sides of the valve, and inside the holes. If there is any yellow/brown residue on the valve, scrape it off. Next, put a small amount of oil inside the valve hole itself (where you put the valve). Next, insert the valve back in the slot by lining it up.
valve oil
Valve, like valve oil which is used in some instuments
Find the cap at the top of the valve cover. Remove the cap and add the oil.
A TIW valve is a type of safety valve that is used in the oil field. This valve prevents a blow out when drilling for oil.
You may have a bad pcv valve.
24 valve 2.0 litre
There should be some sort of plug or cap in one of the valve covers. Check the owner's manual to be sure.
There is an oil cap on the top of the valve cover. Remove the cap, add some oil.
Some of the 2000 models have a PCV valve on the back of the valve cover. The other models do not have a PCV valve, but use an oil/air separator instead.
Your trumpet valve sticks because it is to dry if you want to fix it buy some valve oil undo the valves and put some along the metal piece.
Valve cover gasket? Prevents oil from leaking out of valve cover Valve seal? Prevents oil from entering the combustion chamber.
The bypass valve in an oil filter allows the oil to bypass the filter if the filter becomes clogged. Some filters also have an anti-drain back valve when the filter is mounted in such a way as the oil could drain out of the filter. This valve prevents the oil from running back into the engine out of the filter which would cause the engine to be started with an empty filter every time.
Inside of your valve cover you will find a magnet. It's main purpose is to keep metal shavings from getting into your engine oil. If the shavings were to make it into your oil it can mess it up