there called window scrapers and you can get them from Dave barton or ipd usa
The window frame.
It is pressure-fitted into a rubber gasket and held by a flexible mastic substance.
Mine had a small rubber plug on the outside, lower edge of the unit.
If you are talking about the seals at the bottom of the window on the outside,and you are changing them(discarding the old ones) grab with a pair of pliers and jerk em off. Lightly tap on with a rubber mallet.
Window Rubber seal
THIS IS CALLED WINDOW GASKET TRIM
Assuming that the window is rolled up, you must have a bad rubber door seal on the passenger side.
You might try reprogramming with original 5 digit code. Also might try looking for broken wires in the boot where the wires go between the door and the body of the car. To remove the keypad, roll the window down and pull the rubber/fuzzy moulding away from the top corner exposing three screws along the inside of window opening. Unscrew the screws and loosen and remove the black door pillar moulding with the included keypad. Should be able to unplug and remove keypad from moulding.
Does this car have a safety lockout of the passenger switches? It's probably activated. If it was just one passenger window I would suspect a broken wire, most likely in the rubber bellows between the door and frame.
how do you remove rear window 85 feiro
Yes
Of course not. When was the last time you saw a vehicle without a passenger window.