0
Where can you found a IAC valve gasket for a 1991 Mazda 626 DX?
Wiki User
∙ 15y ago
Napaonline.com pick you vehicle on the left and browse the gasket section
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
What is correct torque for 1991 dodge Dakota valve cover?
If you are asking because of your valve cover leaking oil, there was a recall on that year valve cover gasket.
Do you have an EGR valve on a 1991 Acura Integra 1.8?
no the do not but some gaskets kits will come wit a egr gasket
What is the easiest way to replace a head gasket on a 1991 GSI Storm?
There is only one way to replace the 1991 Storm head gasket. anything in the way of getting to the head has to be removed (intake, hoses, etc..) Then the valve cover and head will have to be removed to change the gasket.
What is wrong with the engine of the 1991 Acura Legend when after it has been running for a while a burning oil smell occurs?
Gasket is leaking oil. Valve cover gasket is likely suspect.
On 1991 acura integra were is idle air control valve located?
The 1991 Acura Integra idle air control valve can be found on the firewall. The valve will be on the drivers side of the firewall.
Where is the idle control valve located on a Mazda mx6 1991?
The idle air control valve is located next to the throttle body. It is connected to the air cleaner hose on the top of the engine.
Where can I find a 1991 Mazda Astina stereo wiring diagram?
Try this - it's the best thing i found... so far... http://www.installdr.com/Harnesses/Mazda-Wiring.pdf
How do you remove brake drum on 1991 Mazda 323?
how do remove the brake drum on a 1991 mazda 323
When was Mazda Navajo created?
Mazda Navajo was created in 1991.
Where is the check valve on 1991 Chrysler new yorker salon found?
Fuel pump check valve is on the pump in the tank. vacuum check valve is in the line going through the firewall.
What is the switch in the center of the dash on a 1991 Mazda 626?
I found out what the switch is. It osculates the two air vents it sits between.
How do you replace the valve cover gasket on a 1991 Toyota MR2?
pull spark plugs after numbering plug wires unbolt anything atached to valve cover remove valve cover bolts gently pry cover loose from engine don't damage gasket surface sometimes you need to tap gently with rubber mallet to get cover to turn loose clean all surfaces replace gasket with a little sealant parts house will tell you witch kind to use then reverse process.
