Want this question answered?
It should come with the lawn mower in the box when you buy it. Go to the manufacturer's website. You should be able to download one for your model, or one close to it.
Yes and no. Some modern lawnmowers are designed to 'mulch' the grass. That is, when used without the grass collection box/bag, they chop the clippings very fine and dump them on the lawn as you mow. This, if done every second or third cut, actually helps the lawn by feeding it. The grass needs to be quite short already to do this. If it is too long the mower will continually clog. If you leave heavy grass clippings on you lawn you will prevent light from reaching the grass and therefore stop photosynthesis and the grass under the clippings will die.
Horitonal or Vertical Output? Horsepower? Keyed with 1/2 moon or full slot shaft? Gear or v-drive system? to comparable ability to transfer power to wheel drive system.verticle.6.5. full slot shaft and gear its a push lawn mower
Air filters are always on or at least very near the carburetor usually in a box or canister
You will need the model number off of the mower. It is usually under the seat. Go to www.managemyhome.com and enter your model number in the appropriate box on the right side of page. You can view and download manuals that are available.
u look in the box it came from (improvement) The manufacturer of your lawn mower can be determined by both the name on the unit and the model number. For instance, if it is labeled "Ace Hardware super duper cutter" it is likely made by MTD. MTD produces the majority of the private label push mowers on the market, Murray also produces some. If you can provide the name on the machine as well as the model number, then the manufacturer can be determined. Kevin
If you are talking about a small engine such as a lawn mower, the air gap between the coil and the flywheel is usually is .015 to .020 of an inch. A piece of cardboard from a cereal box can be used as a gauge if you don't have the proper gauges.
yes they can.
Yes, Check the related link.
You can't put a vertical on a go kart, not without expensive right angle gear box's. You need a horizontal engine. No you can use a Vertical engine with a pulley take the spindle off the motor and replace a pulley there it will not be that difficult make them turn if i could send you a diagram but I don't know how to but you would have to size pulley on each axle a big and a small ill try to send a diagram the people that telll you otherwise are stupid. Acually go to youtube and research that, theres a video there that will compltely answer your question. =)
yes they can but not too much
No difference. The cost could be a bit less from a box store.