advance or autozone should have them
The 1987 Pontiac Trans Am shifter knob is held in place with a retaining clip below the shifter knob. Push the retaining clip together and the shifter knob will raise off.
The 1997 Pontiac Sunfire front bumper is held in place by six retaining clips and for retaining bolts. Remove the retaining bolts and pry outward on each retaining clip.
TRY THIS OPEN HOOD--WITH ONE HAND PUSH IN ON THE HEADLITE, WITH THE OTHER HAND, INSIDE, PULL UP ON A WHITE PLASTIC RETAINING CLIP---THE ASSEMBLY IS RELEASED--PULL IT OUT, FORWARD, THEN CHANGE BULB AND REINSTALL. BUDSBAND
The 2006 Pontiac door panel is held in place by eight retaining clips. Pry outward on each retaining clip. A retaining screws near the door handle will also need to be removed.
well i don't know what year car you have but for the 2004 model remove the headlamps then reach down to the fog lamp/signal lights to remove the headlamp assembly (easy) open the hood locate the white tabs while pushing rearward on the headlamp ,pull up half-way on the white plastic retaining clip align the square cut-out on the retaining clip with the notch on the headlamp pull the headlamp assembly straight out from the vehicle (may need to wiggle it a little) summary : pull up on white clip ,line up the square hole and pull the assembly out now for the signal and fog lights reach down where the headlamp was and you have access to the bulbs just twist and remove,make sure you know which bulb you want ..top / signal-parking or bottom / fog lamp i was shocked at how simple light bulb replacement was on my 2004 grand prix, no screwdrivers needed for access to front or back bulbs littlefoot
The 2002 Pontiac Bonneville rear door panel is held in place by eight retaining clips and two screws. Remove the screws that can be found near the door handle. Pry outward on each retaining clip to remove the door panel.
The retaining clip on the end of the axle is distorted. Replace the retaining clip with a new one. Position the retaining clip with the opening facing up when installing.
The gear stick not is held on with a retaining clip. The retaining clip is just below the gear shift not. Hold the retaining clip in, on both sides. The knob will come off.
It is a form of retaining clip used in many industries
Remove the wiper arm retaining clip. The retaining clip will be just below the wiper arm connection. Hold the retaining clip in and the wiper arm will come off.
I assume you mean the plastic clips that are used to hold various body panels in place? Try Northland Fasteners (google it) I used them before and got the clips about 10 times cheaper than the dealership.
The windshield wiper arm is held in place by a retaining clip. Hold the retaining clip in and the windshield wiper arm will come off. Put the new windshield wiper on and read lease the retaining clip.