In a movable pulley system, the effort comes from the person or machine pulling the rope.
The bolt that holds the pulley to the drive gear for wash and spin may have come loose and the pulley is free-spinning or the gear has come loose from the shaft. At worst, the gear is broken.
simple pulley simple pulley
a flag pole is a pulley
A fixed pulley is a pulley that is attached to a support. It does not reduce the effort needed to lift the load, but rather changes the direction of the applied force.An example of a fixed pulley would be the rope pulley on a well. This is a fixed pulley because the pulley doesn't move (it is attached to the overhead structure).
No it is a lever because you are pushing it forward. If it was a pulley, you would pull it and the object would come down.
The pulley needs to be removed before you can extract the pump, you can get the pulley removal tool at a car parts store.
You may need a pulley (aka gear) puller to pull it off of the crank. The puller comes usually with bolts or claws you can ancor onto the pulley...
That depends on how the pulley is mounted on the motor. If the pulley is welded then no most likely you will have to cut it to get it off. However, if the pulley is fixed to the motor using a bolt/s or other fasteners then yes. Warning: The pulley could be press fit onto the motor. If this is the case it can come off but might not be able to ever go back on.
crankshaft pulley bolt is left hand thread,so it will come out opposite direction to normal bolts
Loosen the tensioner pulley. When the tensioner pulley is loose the belt will come off. Put the new belt on and tighten the tensioner pulley.
In a movable pulley system, the effort comes from the person or machine pulling the rope.
Most bolts turn counterclockwise to come off. Year, make, model and which pulley would be helpful.
You can change the serpentine belt on your Chevrolet trailblazer, by loosening the tensioner pulley. With the loosened tensioner pulley the belt will come off easily. Tighten the new belt with the tensioner pulley.
The belt tensioner pulley is held in place by a retaining bolt. The retaining bolt is in the center of the pulley. Remove the retaining bolt and the pulley will come off. Reverse the process to install the new pulley.
Loosen the tensioner pulley on your 1988 Chevrolet Corsica. When the tensioner pulley is loose the serpentine belt will easily come off. Put the new serpentine belt on and tighten the tensioner pulley.
The bolt that holds the pulley to the drive gear for wash and spin may have come loose and the pulley is free-spinning or the gear has come loose from the shaft. At worst, the gear is broken.