It is important to know how the engine of a car works. In a car, the spark plug cables connect to the vehicles spark plugs.
What is the proper spark plug wire placement routing to the distributor for a 1994 Honda civic cx
It will have a black cap on it with 4 wires coming out and each wire going to a spark plug. Follow the wires from the spark plugs backward and you will find the distributor.
The spark plugs in a Honda VTX 1300 can be removed by first removing the spark plug wire. Twist the spark plug out, using a spark plug socket. Reverse the process to install the new spark plug.
If your Honda CRV cranks but won't turn over because the spark plugs are not getting spark, ensure the wires are connected. A loose spark plug wire can cause this issue.
First: Make sure your distributor cap is correctly attached. Second: Assuming you have one of the plugs out of the car, that the pluy wire connection to that plug is solid AND that the threaded part of the plug is well grounded on a non painted surface of the car.
1-3-4-2
The firing order is as follows: cyl1--cyl3--cyl4--cyl2.............(1,3,4,2)
Check the plug and the wire.
The first thing to do if one cylinder is not firing on a 1989 Honda Civic SI, is to disconnect the battery. Then remove the spark plug wire and the spark plug. Check to see that there is no oil on the plug and it has the right gap measurement. Then replace the spark plug and wire and try the engine again. If it is still misfiring, change the spark plug. If that does not fix the problem, have a compression check done for that cylinder.
The power mirror, on your Honda Civic, has three wires. There is a red hot wire, a black ground wire, and a white auxiliary wire.
To replace the spark plugs in a Honda Fit, start by ensuring the engine is cool and disconnect the negative battery terminal. Remove the ignition coil or plug wire to access the spark plugs, then use a spark plug socket and ratchet to unscrew and remove the old plugs. Before installing the new plugs, check and adjust the gap as necessary, then thread them in by hand and tighten them to the manufacturer's specifications. Finally, reconnect the ignition coils or plug wires and the negative battery terminal.
red